Casolly Press Pollen 5.5 inch Herb Press Tools

This had some of the best reviews so i purchased it, Its much larger than i imagined but thats my fault really for not reading carefully. The problem is that once it arrived i inspected it and there were scratches all over the metal and even some metal shavings in the chamber and i have no clue what wouldve caused that unless it was practically thrown around or just some crappy metal and i certainly dont want that in my "pollen". Also the little puck fits in the chamber pretty loosely so theres likely to be matter that squeezes through that gap, I havent actually put it to use yet. The last thing so far is when i ran my finger around the screws for the caps to check if there was more metal shavings (which there was a little), it was so sharp and jagged that it cut my finger so it obviously wasnt manufactured well. And this is all before even using it, big disappointment

Upon unboxing, and testing out the threads for functionality, the disc attached to the screw bound up inside the chamber and gouged the crap out of the inside of the chamber. After some TLC with a file the burrs are gone and it no longer binds up... attempted first use, and my disc fell apart upon removing it from the chamber. Likely because I am not strong enough to turn it tight enough and keep the chamber from spinning in my hand. Perhaps a tab on the outside of the chamber would make that less of an issue. Gotta find a way to keep it from spinning so I can tighten it down further and then see how everything goes.Update: found a large enough crescent wrench to fit the base stationary so I could keep it from spinning in my hand, which would have worked out perfectly.... however.... after tightening it down with the assistance of a piece of tubing on the handle to assist with my lack of strength.... when I attempted to back off the handle so I could un screw the end to remove the spacer and disc..... the rivet/screw that attached the handle to the threads failed and I was only successful in removing the handle from the press. SO.... after using a towel (to protect the threads) and another wrench to grab onto it.... I qas able to back off the threads enough to be able to open the cap up to remove the puck from the chamber.I don't think this is going to work for me like I thought it would.Back to the drawing board.

Just what I needed. It is large for ease of use and pretty to look at. Will buy from this seller again.

Used three times and the attached to the screw bent about one degree so now it scrapes down the side of the tube and get shavings in your material and it will not go back in place I'm not really sure what happened but I would not recommend buying this product

Not impressed with the size of the wafer it makes to big to swallow and it's very hard to operate with my hands. Put it in a box where it still sits.

Nothing I would recommend, after some light use top stripped and could no longer use

This press works extremely well and is very heavy duty. Cleans up with an alcohol prep pads easily. I love this product!

After a few uses I noticed the bottom cap bulging out. I only use my hands no external tools.