FX Exhaust FX8062

I installed this on a 2007 Toyota Corolla. Worked exactly as advertised and it fixed the well known issue of the exhaust pipe leaking or breaking where the muffler pipe connects to the converter pipe. The part is high quality and I would recommend.

worked on 2005 Corolla between muffler and exhaust pipe. One pipe end had a ding in it (as received). This required some "iron work" to make a perfect circle again as it would not go on exhaust pipe. Other end fit perfectly.Finding this part on Amazon was a bit of a challenge but worth it!

Very easy to use. Took a couple minutes to lop off old flanges and slip these over pipes. I did need to massage one of my exhaust pipes slightly to get this to fit over, but better that than to have a loose connection. I secured my with exhaust clamps. Worked like a charm.

Used this with some 2 1/8" u-clamps (not provided as part of this kit) to fix broken exhaust flange on 2007 Toyota Corolla. I chose to remove the muffler section from the car to check fitment and make it easier to cut the remaining flange off that exhaust pipe section. However, entire repair could probably be done leaving both the muffler and resonator sections on the vehicle if wanting to do that. In my case, the most difficult parts of the repair were getting the muffler section exhaust hangers to release and performing the cut of the remaining flare off the resonator section under the car with a hacksaw. Saved a ton of $$ doing it myself relative to quote to have this done at well-known nationwide repair shop.

This worked great for my 2006 Toyota Corolla to fix the exhaust. I broke right after the muffler and I didn't want to replace the whole pipe. Very easy to install, a real time saver.

Worked great on my 05 matrix (2 1/8 dia pipe) requires that both sides of the existing flange be cut out close to the previous welding seam lines and fitting it over the existing pipe can be a challenge. Once fit you can either use two exaust clamps or weld it in, I opted for the former.

I bought this for my 2007 toyota corolla, exhaust pipe broke just at the connection with the muffler, cutting the pipe wasn't easy and one side fitted perfectly but I realize that pipe on the other side on my car exhaust pipe wasn't as round so a little bit of hammering and it went in, you will need 2 exhaust clamps size 2 (1/8), don't buy the 2 (1/4) as they will no fit and leave a small gap, this kit fixed the problem I hope it will last the rest of the life of the car.