Delippo 12V 10A 120W DC Power Supply Adapter 100V~240V AC to DC Converter 12 Volt 10 Amp Transformer 5.5x2.5mm Tip for 5050 3528 LED Strip Light 3D Printer LED Driver CCTV Security System LCD Monitor

This 120 watt power brick was used to replace an under powered Monoprice Delta Mini 3D printer. This printer came with only a 60 watt brick. It wasn't capable of useful bed heater temps and the brick ran very hot all the time. It couldn't reach the maximum settings that the printer could achieve.This 10A 120 watt brick does get the heat bed up to 60 degrees C and still leaves enough potential power to add LEDs and a few mods to this printer. It also utilizes a 3 prong electric cable while the original had only 2 prongs. It solved the low power problem I expected it to.It does seem to get warm but not as bad as the original power brick.Update 4-8-19: Has been running my Monoprice Mini Delta printer for a few months now without fail. With the old power supply it struggled to get to a bed temp of 55 degrees C. It now does 60 easily and is also powering some LED lighting I added. I highly recommend this bigger power supply for the MP Mini Delta if you need some more power than the original supply gives.

This is pretty big power brick - too big for my needs.It works great with:Pico PSU 160 W | 24 pin 12v | jack: 5.5mm x 2.5mm

Bought to upgrade power supply to 10 amp on my MP Mini Delta. Now I have no issues with the bed maintaining temperature.

Great little supply. No more printer screen weirdness. Temps more consistent.

I use it to power an array of external USB3 drives. So far I run 4 drives off this power supply, and I may be able to push it up to 6 (if I did my math right :-). It runs cool, never overheated and the drives never crashed.

Got this for my monoprice select mini and it works amazing

Great purchase. works well..Thanks