YoungRC APM2.8 Flight Controller Board Built in Compass Straight Pin for RC F450 S500 Quadcopter Drone

APM 2.X is about 10 years out of date, but.... Used this on a quad copter 450 Flamewheel. Was a good learning tool but this is no longer supported in Arducopter. If your looking for current, look at Betaflight F3 or other newer technologies.That said, it was perfect for me to jump into affordable quad FPV 450 build with all the bells and whistles at about 1/2 the cost.Just be prepared to spend a lot of time in the Arducopter archives researching and soldering.Just my .02 worth.

For old tech this flight controller still works good. Be aware that this controller can only use legacy Arducopter firmware. Version 3.2.1 is the last version that supports this controller. If you need to have Arducopter 4.X.X firmware or newer then this board is not for you.

ITS OUTDATED YOU WILL NOT BE ABLE TO PROGRAM IT AS THE SOFTWARE HAS BEEN UPGRADED LEAVING THIS FLIGHT CNTROLLER IN THE PAST! DO NOT BUY! YOU WILL NOT BE ABLE TO USE IT!

si trae un manual seria mas fácil creo que venderían mucho mas los tipos de conexiones son importante estuve que investigar mucho los diferente tipos de coaccione y estoy creo si el fabricante la viniera lista para volar seria un éxito las configuraciones son muy complicada y la pagina no ayuda mucho

Ardupilot calls this a legacy board, I thought I was buying new hotness. So it's missing a lot of features, but so far it flys just fine.

Works great. I used this instead of the more expensive pixhawk, for s500 frame. No issues at all.

Even though it uses firmware a few version back, it is amazing. Worth the money - It did NOT come with the servo cables as pictured. I already had some.

Just okey