8PCS Alloy Upper & Lower Rod Link Linkage for 1/10 RC Axial SCX10 313mm Wheelbase

Tolerances seem a bit loose/sloppy, but once they're installed they can't unscrew themselves so I'm not too worried about that. I only installed the four lower links on my SCX10 Deadbolt so far, since it was only the lower link that had started to fail. I'm not sure if/how the front upper links would attach since the original piece is a Y shaped single component.The price was right and these have provided my truck with a lot more rigidity when climbing obstacles.

This does not directly fit onto the original Axial SCX10 !The measurements given are from end hole to end hole (114mm, 122mm, and 129mm as listed).As someone mentioned on the question and answer section, the shaft is threaded for 1/2 an inch. If you need to cut and shorten as I did, you can only cut off a small amount before running out of enough threads. I cut approx 1/4 inch off of each end.Overall am satisfied, definitely an upgrade from the plastic linkage I was running.

Like - it was a good dealNeutral - as shipped the rod ends wouldn't tighten up and be parallel to each other. Could have used a slightly shorter link and jam nuts for added realism and ability to adjust that. What I did was used a finger nail clipper file to shave down the red spacer the tiniest bit so I was no more than 1/4 turn out from tight then tightened them down. Not a big deal.Zero instructions - so you're own your own putting these on your SCX10. There are 3 different lengths. Longest sets for the rear, shortest links on top. Shorter sets for the front, shortest links on top.Would buy again.

There was only 1 small link instead of 2 so I had to use my current links and switch the ends. Not a big deal but its a little annoying.

Over all nice. Ended up not working for me but nice parts.

Used them on my scx10 build. I use my rig every day and abuse it. These links have held up great.

The links themselves are pretty solid and hold up well. The ball ends are terrible. The inserts holding the pivot ball in place started falling out the second or third run after installing them so I have to replace the ends. I will not buy these again, I'lll continue to make my own with threaded rod and plastic ends.

Links fit good look good .do have a tendency to loosen up one dab of lock tight fixed that .great price work great so far .

One link was a lot darker in color than the rest. Otherwise links are good. Seem solid.

Incorrect measurements. Sturdy, but the connections are very hard to work with (both the rod and the ends are female. Spacers done do anything lol, also doesnt come with front steering rods. Not oiled at all.

Bonne qualiter bien concu!!!!!