Olympic Zeron Epoxy Pool Coating Gallon Bikini Blue

Very nice! Used this to paint the floor of my 15x30 inground pool. Highly satisfied!

Used this product on refurbishing a walls on a baptismal tub that had probably been in use 75+ years - but ugly, with multiple previous repair jobs failing. Ground out the loose plaster and scuffed up the remaining paint that didn't fall off. Patched the plaster and surfaced over all the walls with very thin coat of thin set in order to adhere Mapi AquaDefense waterproofing membrane. Then used about 1/2 gallon Olympic Fusion Plus (for priming rubber)- let set overnight and applied the Zeron to about 60sqFt wall.. Wasn't sure of Zeron coverage for my project so I started with 1 qt Part A + 1 1/3 pt of Part B and 2oz of Zenon thinner, following directions for mixing and letting stand. Started rolling (1/2" sheepskin nap) and it went on great, no dripping or runs and the initial amount mixed was exactly what was needed. Carefully removed tape and lines fairly sharp on the rough surfaces. Set thermostat to 70 degrees and came back 2 days later and it had setup hard as a rock with little fumes remaining. Very good looking paint job. When this job is fully complete (tile on steps and base) - I hopeful the finishes will last for many years.BTW - The Fusion+ (epoxy primer - brushed) adhered to the rubber membrane without issue. Tested use of acrylic latex and topcoat alkyd enamel to the Fusion+ primer and they both seem to adhere well.

I ordered more then I needed and could not return. So measure 2x was pricey, but worth it

Fast delivery, but a little expensive. (No one around me had this product)

Easy to mix and apply. Good coverage over primer on fiberglass pool. Applied in 90 deg plus temp, sets up in about an hour, cures completely in 3 days as stated in the directions. I applied with a sacrificial roller and brush rather than attempt to clean.Looks great ( I used white) and seems to be very durable- time will tell but very satisfied so far.