(2Pack) Nema 5-15P Plug 15A 125V Right Angle AC Plug, Nema 5-15P DIY 90 Degree Plug,5-15P 3-Prong Rewirable Plug,5-15P Household Right Angle AC Plug, Black ETL Verified

Besides being a 90 degree plug, the blades can be rotated to 12 different positions making this plug very useful. I used it in an outdoor outlet where I wanted to keep the cord close to the house. When I first assembled it I had the blades rotated 180 degrees from where I wanted them so I just took out the one screw that holds the blades in place, rotated them, and reinstalled the screw. Works great. and seems well built.

Exceeded my expectations in every regard.

I like the broad choice of angles these offer; that makes them very versatile.I had no trouble cutting / stripping the wires to the correct lengths (each different) or attaching the cap with its single screw. Then again, I'm not brutally ham-handed and I've been doing this sort of stuff for a long, long time.

Great product. Smart engineering design. I’m not easily impressed but this did it.

these connectors are perfect for small spaces like covered outdoor outlets, as there is often not enough room for the cable bend. The installation is super simple, even for 14 AWG romex...a little pricey, but I think well worth it considering the time saved trying to rig up another option

I used this plug to replace a damaged plug from the back of our refrigerator. The cord from the fridge used 18 gauge wire (flat 3-wire), and this plug worked well. My only caution is be careful when you reassemble the plug, making sure you don't accidentally cross thread the screw(s) and then stripping the screw holes. Pay attention to the friction required to remove or loosen a particular screw. It should be pretty much the same when you reinsert and tighten the screw again. If it's not...don't force it. Realign the screw until it goes in with basically the same friction you felt when loosening or removing it.

I had a heck of a time connecting this to my 14 ga wire. I carefully stripped the outer cable sheath and the individual conductors to the lengths recommended on the small set of instructions that came with the plug. Unfortunately, needing to turn the position of the plug so that the prongs were almost 180º from the main prong orientation, caused the green wire to have insufficient length to make it around the center post where the screw holding the plug parts together was. No mention of this on the instructions. I had to fiddle with the wire lengths to make it work. The recommended strip lengths of 1/2" for each cable were fine, but the lengths of the unsheathed wire were not fine.

Good