Specification: Condiiton: 100% Brand New Color: Black Wiring: Export three-wire system Voltage range: 12V 24V 36V 48V Supply voltage: 8V to 50VDC (module normal operating voltage range) Standby current: 0.5ma (silent state) Output power: High power, load current 5A, the pressure drop is negligible. Power consumption: 0.6Wmax Anti interference delay: about 0.6 second Sensitivity: 5-10LX on 30-60LX off Environment temperature: -40℃ ~ +70℃ Related Humidity: 99% RH Working Life: 6500 cycles Detector waterproof grade: IP 66 Use of the environment, temperature: Can not be installed in a corrosive gas environment, minus 25 to 70 degrees. Leads Length: 150mm Product Size: (L) x (W) x(H) 40 x 15.6 x 20 mm / 1.57" x 0.61" x 0.79"(appr.) Package Included: 1x Photocell Switch Notice: Please allow 1-3cm error due to manual measurement and make sure you do not mind before ordering. Please understand that colors may exist chromatic aberration as the different placement of pictures.
Z**S
It works, but BE CAREFUL !
The common white line the positive (like +12V), they call this the "neutral", and the sensor switches the zero line (like 0V), so the "+" and "-" signs on the diagram are right, but the names of lines and the drawing of the small light bulb are confusing.So for example: if the power 12V DC (with +12V and 0V), and we had a light with contact (+ and -):+12V from the power connected to the white wire and the + contact of the light.0V from the power connected to the black wire.The red wire connected to the - contact of the light.(I am not connected to the manufacturer in any way, and I am not taking any responsibility for any fault or damage related to the usage of this product, this is not an official user's manual, but this was my experience. It is also possible, that my sensor is faulty or works differently than the others.)
J**N
works well, wire colours can confuse things.
Works well. Wiring colours are bit confusing. Its the negative side that the sensor switches off/on.For example if you were wiring a bulb to it, you connect the white sensor wire to the + side of your 12v supply/battery, and also run another wire from the + of the supply/battery direct to your bulb.Then connect the black sensor wire to the - side of your supply/battery.The red sensor wire then connects to the negative side of your bulb.Note there is a 5 second delay in switching off and on.Hope this helps you out a bit :)
D**N
hhhm
could not wire correctly, colour s all wrong
Trustpilot
2 weeks ago
1 month ago