TASAN RACINGThrottle Cable Bracket holley 4150 4160 Series Adjustable Aluminum Carburetor Bracket Black

Very nice and well made piece. I had to trim part of it off because it interfered with my linkage but that's a problem unique to my car, not a problem with the part. Overall a great value.

Does the job but I recommend replacing the hardware it comes with they strip very easy and I had to grind out a good bit of material for it to clear an edelbrock carb. But it works once you mess with it a little

I have it on my 351W with a Edlebrock performer and a Holley street worrier. The only thing I had to alter was shave down the one arm for the throttle linkage.

Fit my application perfect !

Quality piece, I should have read closer and I would have understood this bracket is only meant to work with holleys. I was able to take a little material out of the middle and it is working well on my edelbrock. You will have to modify this bracket to clear throttle linkage if using a edelbrock or carter.

It looked and functioned great,if I had to find one thing that’s negative I would say the spring tension is a little stiff.You can stretch them out and soften them some.I would buy again

Springs are a bit too stiff, screws are short so I used red loctite on them.I'm assuming the spring assembly that connects to the throttle arm will wear out since it's aluminum and spins inside a steel arm so I added a heavy grease to alleviate that.overall worth it for the $ compared to others

I had to cut and we'll the front where it boots to the carburetor.The springs are a little to stiff.