30w UV Light

Amazing, works perfectly for my room setup and has quite a wide throw compared to traditional blacklight bulbs and is brighter by far. Feels sturdy, like other reviews mentioned the cord is on the short side but not a deal breaker.

Pros: works as advertised. Very bright and I’m using it to cure prints. Works great on glow in the dark items.Cons: even with the switch off there is clearly a wiring issue and the LEDs stay on but very dim. Has a very short power cable.

Bright light, but short cord and gets really hot when left on for longer than 1hr

It’s perfect. I use it for light when developing emulsion for screen printing. It’s nice & bright so I can still see in the dark without exposing my screens.

Do not buy this product if you are planning on using it for 3D printer curing. You will have it on for a couple hours and it will burn out leaving you with a brick of a light. So far I have gone through two of them both of them stop working after a few hours of on time.***2nd time owning***This light works great for curing my 3D prints from my SLA printer. The first one I had stopped working after a month of use but the support contacted me and had a new one sent out really quick so I had no downtime. It has need going good since then.A+ productA+ support***Old review below***This product was working great for a month. Then all the sudden out of the blue it turned off and now it's not turning back on.

For the most part, it does what I want with it which is to cure resin. My only problem that I noticed with it is that the light would go out every now and then even though it was on. All I did was adjust the cord and it worked again. So it seems the cord is the connection with the cord is the problem.

When I ordered it, I didn't really think it would be strong enough for parties. But it's definitely strong enough, the price is amazing, and it's so lightweight! plus the waterpoof is an amazing plus i really enjoyed it and defiantly an amazing buy Really love it. the only down side would be the cable it came with is annoyingly short had to buy extension but other than than highly recommended

Bought to use with curing 3d printer resin. The light works reasonably well for this. Unit gets quite warm and cant really tolerate being mounted in a face down position. More interesting is that the off switch never fully turns off the light. Look close at attached picture and you will see the leds are glowing with unit plugged in and switch off. Simple solution is to just unplug the light. I am not returning it due to hassle but I would not buy it again either.