No Residue, Non-Reflective Gaffers Tape for Photography and Filming, Removable Strong Adhesive for Cords, 3 inch x 90 feet, Black

Excellent product, same or better than other, brand name gaffer's tapes, but less expensive. Sticks well, comes off cleanly even from marble, polished wood, and glass. This is a GAFFER's tape, not duct tape, so there are limits to how hard it sticks, but it does better job than expected. Highly recommended FOR ITS PURPOSE.

I’m not one for giving four star reviews, but this gaffers tape deserves it. Seriously. I’ve used it for three years and I love it. It adheres to just about any surface, including rough concrete, and leaves little if any residue. The residue can be easily cleaned off with isopropyl alcohol or a bit of acetone. I found it always leaves a bit of residue on glass and other smooth surfaces, but cleans up easily. It does a far better job than duck/duct tape. It doesn’t seem to be affected by weather or by water. When I run out I’ll buy another roll in an instant.

I had an old automatic 35mm camera that I loved using as a kid that apparently cost my parents a pretty penny back in the 80s. I had dropped it at one point and broke the clip that holds the film door closed on the back of the camera. This clip also engaged the locking mechanism that loaded the film and indicated to the camera when the cartridge was removed to clear then"exposed" indicator from the screen on the camera. I did buy a replacement camera once upon a time at a yard sale, but I just had such fond memories of this camera, and was familiar with the kinds of pictures it took that I wanted to get it going again if possible. I was able to see that manually moving the door latch switch to the closed position would keep it there, and the camera would go through the film loading process, and I could see that the camera was still able to auto focus and the shutter was functioning normally. My only issue was how to keep the door of the camera closed once I had film loaded. The last thing I wanted was to have a situation where whatever tape I used would lose its stick and the door would pop open exposing the film in the camera. I considered electrical tape first but in my experience, it doesn't stand up to constant handling and the adhesive melts from body heat making a mess everywhere. Not only would this most likely cause the tape to fail and the door to open, it would probably leave the camera a sticky mess. Then I thought about duct tape. We all know the saying, if it doesn't move and it should, WD-40, if it moves and it shouldn't, Duct Tape. But I've had similar issues with the adhesive on duct tape failing after some time, and it definitely leaves behind residue. My biggest reasoning for worrying about residue is that if I wanted to use this camera more than one or two times, I'd need the surface of the camera to remain pretty free of residue so tape can continue sticking to the surface each time I load a roll of film. Then I had the realization of Gaff tape. No residue, great stick. But then I saw the prices of Gaff tape which was crazy out of my budget. For the prices I saw, it may have been better to just deal with removing the residue from something like duct tape and hope to not have any tape failures while film was loaded. Then I came across this Gaff tape. I saw some very mixed reviews about it and saw some people mention a possible formulation change in the adhesive through the years. But at the price for the roll, and knowing I won't be using very much at a time, I decided to go for it and to just do a dry run first before putting any film in the camera. This tape worked perfectly as I'd hoped. In my dry run I made sure to wear the camera around my neck so it got bumped around throughout the day. I put it in and out of my bag. I made sure to hold the camera and mess around with it. The adhesive never melted or gave out. I had it on for about 3 or so days before deciding to pull it off and go live with actual film and not a single bit of residue was left behind on the body of the camera. For context it is made out of plastic and there is texture on some parts where the tape was placed. This even ends up covering the tripod mounting hole that I don't use anyway and the tape never lifted. I can't necessarily speak to this being used in the field for Gaffing purposes but I can say without a doubt that this tape delivered exactly as I'd hoped and I'm beyond happy with my purchase. I've shot 2 rolls of film in this camera with no issues, and I even dropped it once while it was taped and the tape didn't give way. When I run out I will definitely be purchasing this again.

Gaffer tape is supposed to be a high tack, low residue tape. Amazon got the first part right. This stuff is really sticky. Wikipedia says of Gaffer tape: "The synthetic adhesive typically leaves little or no residue and will generally not damage most surfaces when it is removed." This stuff leaves a trail of black goo wherever it has been even if it has only been there briefly. It even goos itself to a shelf if the roll is laid flat. This tape should only be ordered along with an 8 oz or larger bottle of Goo Gone. UPDATE I needed to reseal an Amazon plastic envelope and this tape was the handiest. It took a long time and a lot of effort to get the required length of tape off the roll and by then I was covered with the adhesive that was supposed to be on the sticky side of the tape. And the envelope will likely stick to anything it comes near since the top, supposedly non sticky side of the tape is sticky with adhesive stuck to it from the previous layer of tape. I grabbed a roll of paper towels to clean up and the paper towel stuck to the adhesive on my fingers. I grabbed the bottle of Goo Gone and stuck to it. Once I got the Goo Gone opened I was able to unstick myself from the paper towel and after liberal applications of Goo Gone and a lot of rubbing I managed to get the adhesive out of my fingerprints. Then I had to use more Goo Gone to clean the adhesive off of the Goo Gone bottle. I need to throw this tape out and go buy a roll of legitimate gaffer tape.

Right off the bat, this is not standard gaffers tape. Possibly it's the matte surface that is at issue, but this is very difficult tape to use. The adhesive sticks to the next layer on the roll like it's never coming off. About the only way I could get a decent length was to hold the roll in my left hand and yank outward and down, HARD, with my right. Once it is off the roll, it seems to work like other gaffer tapes I've used. The matte black does its job and blends into a black surface. If you have arms like a gorilla you'll appreciate this tape, but if you have more than five feet or so of cable to secure look for other options.

High quality tape at a great price! I used this tape to make my own V-Flats, which for those outside of this space, is basically a portable surface to reflect or absorb light in photo/video shoots. I will also be using it for it's true purpose, taping down electrical cords on sets! Durable: This tape went on smooth and once secured to the foam boards, has stayed put. Time will tell on long term durability but the rolls offers 90ft so I have plenty left for pathes and replacements. Size: Matches the description and comes in at 2 inches wide and 90 feet long! Ok, I haven't measured it length wise....but I trust them on this. Thickness and appearance: The right amount! Feels lightweight yet durable.

Me gusta que sea delgada pues se adhiere mejor y para fijar accesorios es excelente pues es discreta, sin brillo, además la parte del pegamento es negra también eso hace que sea mas discreta (otras vienen con pegamento blanco y muy rígidas ), además la siento mas fuerte, el único detalle es que da algo de trabajo cortarla con las manos pues como es muy delgada se puede doblar el borde, solo es cosa de tener cuidado de hacerlo bien. Y lo mas importante es que es muy fuerte, con muy buen pegamento y no mancha al retirarla.

Lol I thought this was grip tape and just tried regripping my golf club with it. Didn’t go well. Probably works good for its intended purpose though😂🤦🏻‍♂️

A friend suggested this to improve the acoustics of my keyboard switches (put it inside the switch, so the tape cushions the plastic) and it works great. It also helped with the acoustics of the keyboard. While using it, I saw how clean and easy it was to remove the tape. I just started using it for everything that I knew I would have to removed it eventually. It keeps PCB in place while I was soldering, some cables together for organization, etc Do not use for hot stuff, like inside a laptop, there are tapes proper for that.

No se puede utilizar se desprende el adhesivo al tratar de desenrollar para ser usado y la mitad de la cara de la cinta queda sin adhesivo

Update November 2025. I don’t know why but we used the same roll again and it literally ripped the wood from its surface. Overtime the stickiness became unbearable and just handling the tape is an absolute mess. I won’t be buying it again. Reduced the stars because of this. Original: purchased this as a temporary seal going into the winter for the attic knowing we had to go back in, in about three weeks with plans to do our usual attic seal after. We then noticed the closet where our attic hatch is, is much warmer than it was. We've used winterized sealants and plastic to close this for years and the closet was always so cold in winter, creating heat loss too. Then removing everything is a pain. Surprisingly, there are no drafts with this on, so it’s now our permanent winter seal. I had to take it off once because we had mice. Came off easy, no residue. Then 3 minutes to put the tape back on. My husband and I are so grateful for the accidental find.