Quiet-Flow SS 21054 Direct Fit Exhaust Muffler 3" Inlet (ID) 3" Outlet (ID) for Dodge Ram 2500

This is my second one of these mufflers. The first I put on a 500hp 6.0ls powered Tahoe with long tube headers no cats, a vibrant ultra quiet on each bank, then electric cutouts when I want it loud. After the cutouts it merges the dual 3” down pipes into a single 3” y pipe and leads straight to this muffler then out the back. In the truck with the cutouts closed it’s essentially quiet as stock, even at WOT the exhaust note is very quiet with this muffler and the dual vibrant ultra quiet’s and that’s what I wanted for towing long distances on the highway. This muffler has been in this Tahoe for close to 4 years now and still looks and sounds new, despite lots of 7,000rpm clutch dumps. The second of these mufflers I just recently bought and installed on my 1996 k2500 with a basically stock 5.7l small block. That truck has stock manifolds but no cats and dual 3” y pipe into a single 3” which leads to this muffler and out the back. Without having the dual resonators like my Tahoe has there is a distinct muscle car kind of idle note when you stand back at the exhaust exit. It’s almost like a low growl that lets you know there’s a nice healthy V8 under the hood. I side the truck it’s basically as quiet as stock maybe 1-2 decibels louder than stock but the ac blower motor is louder as is the engine noise itself. It’s exactly what I wanted with this truck because it tows a lot and I again didn’t want it screaming at me on the highway with a heavy load. To sum it up these mufflers are very quiet and if that’s what you’re looking for you’ve found it. I tried half a dozen other combos on my Tahoe and were disappointed every time with either drone or some weird note that drove me nuts. I will absolutely buy these again!

Dimensions are accurate and it is quiet as advertised.

Works badass quieted my truck just what I wanted

Im gonna leave this at 4 stars for now because I havent tested it yet. I literally just got done installing it. This says its for a dodge but I just put it on an f53 ford motorhome chassis. So we will see. As you can see in the photos, its about the same size, just about 6 inches longer than the original. I posted the measurements in my pics for yall. Only thing I didnt measure was the inlet and outlet, those are both 3 inches. So far its nice, the inlet side of the muffler is marked, but on mine its the offset side, not the center. I dont have gas yet to start the rv up and listen to it, but I will soon. If I have any issues or if it works well, ill come back and change my star rating but overall out of the box, its nice.

Very quiet it looks very well made very story fits perfectly this installation if you have the knowledge

Seemed like every time I fixed the exhaust system my Nissan Titan kept getting louder. First it was the exhaust manifolds cracked as many have. I wanted to keep the truck a while and didn't want them to crack again so on went the JBA long tube headers. Then I had to do the b-pipes, and after that the rest of the exhaust. Every time it got louder and louder. I already had a resonator but the cab was still too loud. Not the case after installing this walker SS muffler. It was 6" longer than my performance muffler but a bit lighter. I gotta say it is weird, feeling the truck pull hard and with the AC and stereo I can barely hear the engine. Sure people dont jump or turn around when I start her up but that is OK. I was looking for a well priced, stainless 3" in/ out quiet muffler and this was exactly what I wanted.

Love this muffler! Returned performance, almost silent.

I used this on my LS Swap because my exhaust before was very loud.. I went with a Walker quiet .. over all it's a out 20% louder then factory ( I have no cats) how ever on a cold start it has a rattle on the inside Muffler like a plate is loose... only had it on for 2 days...