BURLYBrand Easyboy Lite Clutch B17-117

Very easy to install way easier to pull heavy duty spring. 1 hour job. Reducing pull weight is a must for us older folks.

I have a Screamin' Eagle race clutch set at a 145# pull to handle the 130 #s of torque and 130 HP out-put of the Screamin' Eagle 120R engine in my 2006 Dyna Street Bob. The clutch was too hard to pull and I actually hurt my arm after putting 1,000 miles on the original set-up to break in the engine. Burly's Easyboy clutch does what it says. I installed it in minutes and I can now drive my bike knowing my clutch (and my arm) are going to be just fine. The reduction in pull was roughly half of what it was before and although my clutch is still way more than the factory pull, I had no issues putting over 3,000 miles on my bike after the Burly unit was installed.

It made the clutch on my 2017 street bob very easy to pull. No more fatigue during my lane-splitting commute. Install is simple but you will have to possibly remove the exhaust which is a headache and there is a spring component that will need to be taken off and it requires a special tool to avoid breaking the component. Would recommend.

I did this the same time I installed larger risers and a new clutch cable... Pull feels about the same.

For the price, it's worth a try...I'm in the process of changing the handlebar configuration so all cables & lines needed changed out anyway...I gave 4/5 cause I haven't gotten a chance to test it out yet.

This little item was a godsend for the wife's new (used) Heritage Softtail. The previous owner installed a very heavy duty clutch spring which made pulling the clutch lever even a challenge for me and wold have given the wife fits. This little device saved the day - the clutch pull has been reduced by at least 40 to 50%. Installation was easy enough using the included directions even for an average wrench turner. Highly recommended.

I just bought a 2016 Harley Softail Deluxe and could barely pull the clutch in at all, it was so tough for my tiny little hands! Oiled it up, cleaned it out....still didn't change much at all. The Harley brand easy pull clutch was very expensive and I didn't want to spend all that, so I bought the Burley and had it installed....what a HUGE difference!! It is so much easier to pull in now and doesn't hurt my hand at all, I'd say its about 80% easier than before.

Lighter clutch on the harley now. Works great.

Not to difficult to install on 2000 FXDWG. My clutch was super heavy. I'm not a wimp, but it was a bit much in stop and go traffic. The kit did reduce the weight of the clutch, but not as much as I was expecting, but I'm perfectly fine with the way it is now. It is basically the same now as my buddies' Harleys. I can ride all day and my hand doesn't suffer.

I always buy a clutch lightening device for harleys as they can get tireing while sitting in or sifting through traffic. this is my first burly brand easyboy and I have got to say it's like riding a different machine this is an excellent piece of kit (fitted to a 2000 wide glide twin cam 88) fiitting requres correct tools and a little diy knowledge (or a manual) be sure to buy correct device for your machine i think it's best to double check on burly brand site. but buy here to avoid large postage and import charges and of course it's quicker.

Works Great i Recommended