Wrought Iron Patio Furniture Feet Cap Glides and Outdoor Table and Chair Leg Floor Protector Pads - 1.5 Inch - 24-Pack - Black

Ladies, you've put together toys that were harder!! I didn't have a can of acetone, so I used Windex & a paper towel, for cleaning the the foot cups. I also needed a flat head screw driver to pry the old ring out. Make sure the inner cup is dry. Take1 foam and one webbed cap. Remove the inner circle first. Then remove one side of the paper backing, and match it to the rim of the webbed cap. Push it between your palms, to get a good seal. Remove the other paper, and place it in the foot cup (I found that from bottom rim to the top rim worked best.) While I had the chair on edge, I applied 3-in-1 Silicone so that it would no longer squeak when turning. Finish all cups, including your table, go get a glass of wine & a good book, and RELAX! You've earned it!

These little chair glides work great. They are easy to pop in, and the sticky foam pad keeps them in place and adds just a tiny bit of cushion . I have used them on two different sets of table and chairs. They protect my concrete patio from rust rings.

When the product arrived it was exactly as expected. The instructions were very simple to follow and the product fit great. I am very pleased with this product. My patio furniture is very old and the gliders were gone. I was very excited to find these.

These are slightly undersized in diameter for a 1 1/2" opening, probably to accommodate inexact manufacturing of the bottom cups by different makers, but with the supplied materials they fit. I have only had them mounted about two-weeks but so far they seem to work fine.

I love the design. It’s even better than the factory design. Easy to install.

They tap in nicely and don’t fall off.

Easy to use. Excellent directions. I replaced the glides on 4 patio chairs in about 45 minutes and I'm not handy at jobs like this. Highly recommended!

I used this product to fit older wrought iron chair feet to protect a softer cedar deck. I have struggled with other more rigid glides, and it was extremely difficult to get them to fit the feet even with heating and slicing some of the plastic to get them to fit and much hammering. Took hours! And these others started coming off pretty quickly.This product fits easily inside the chair feet, and it is done in just minutes. Initial order has lasted all summer without a hint of coming loose. I can't comment yet on longevity, but they are so easy to install I will have no problem ordering and installing more if need be after a few seasons. Highly recommend then as they are likely to fit a variety of wrought iron chairs with slightly different size feet.