Color: White Dimensions: 53 x 120 x 40mm (approximate) Probe line length: 236cm Power: AC220V 50Hz Temperature Control Range: -9 to +60 degree, cooling and heating mode can be selected. Maximum load power: 6000W Operation Instructions: 1, Plug in the controller and the current actual temperature will be displayed on the bar, the status bard displays(run), and it will run with the set temperature. Set temperature can be memorized. 2, Setup Button: Setup Button is used to switch between the operating temperature and the set temperature. Push the button and[setup] will be displayed, and then it turns to setup. Push the button again and(Run) will be displayed, then it turns back to operating status. 3, Temperature"+" Button: To be used to turn up the set temperature. When it is on(Setup) status, the temperature will increase 1 degree for every push, the temperature will increase continuously if holding pressing the button till 60°C. It will turn back into operation after 5 second's release. Set temperature will be memorized. The temperature will not change when plugged in againater switched off. 4, Temperature "-" Button: to be used to decrease the temperature. When it is on (Setup) status, the temperature will decrease 1 degree for every push, the temperature will decrease continuously if keeping pressing the button till -9 degree . It will turn back into operation after 5 second's release. Set temperature will be memorized. The temperature will not change when plugged in again after switched off. Package including: 1 x Thermostat (UK Plug) 1x English manual
G**E
it switches itself off if the heater runs for more than 60 minutes
If you get a cold spell and the heater is struggling to maintain the set temperature and it runs for more than 60 minutes the unit shuts down - result cold green house and damaged plants in my case orchids This feature should be able to bedisabled. Nice well made unit spoilt by this feature
S**X
Ok but issue
The plug works ok I just use it to work a heater for frost protection. The thing that’s wrong with this is it cuts the power after it has been on for an hour. This is not helpful if it has not reached your set temp.
A**
Easy to set up
Not sure on accuracy but close enough for sure.Easy to use and set up, used to circulate air in high roof space to redistribute heat via a fan, works perfectly
C**A
Worked for less than a week
Currently using this for a reptile heat mat. It worked fine for a few days. Now it's shutting off once max temperature is reached and then it doesn't switch back on so the mat stays off and there is no warmth being supplied to my gecko. I'm having to unplug the mat from the stat & and plugging it in the socket next to it. Wait for it to heat up to a point where the stat will read that it needs to shut off in the hope that that resets it. That works for a few hours until the *on* switch mechanism stops working again.
Trustpilot
2 weeks ago
2 weeks ago
