Dalton Enterprises 36099 PLI-STIX 60 Ft. Asphalt and Concrete Crack Filler (2 Pack)

This product works very good at filling my driveway cracks. Unlike some similar products, this product self levels and lays smooth to the side surface. I especially like that I can make repairs regardless of the weather conditions. Rather than push the product into the crack and then heat, I like to heat it from above the crack and let it drip into the crack and repeat as needed to fill the void.

Excellent product, very easy to use. I found it helps to warm up the ply sticks by leaving them in direct sunlight before applying them to the crack, this helps make the product a bit more malleable. Also, instead of using a screwdriver or putty knife to push the product into the crack I used a rubber mallet and it worked much faster.

the product seal cracks much better than the liquids. Have had this on cracks for a couple of years in 100+ and 0- temps and it has not opened up like the ones out of a bottle.obviously however a ittle more costly and a little harder to apply (using a torch)

I ordered a double-set of this 1/4" 2x. I also ordered a 1/2" small pail. They both adhere well to my asphalt driveway and concrete curbs and didn't crack after one winter. Adheres the best of several products I tried including acrylic tubes. After 1 winter the acrylic I applied has a single small crack running lengthwise in most of the cracks I filled. Not so for the PLI-Stix. I did find that the 1/4 inch was sufficient for most cracks and it melts faster than the 1/2 inch so uses less propane. I also like both sizes in that as long as the already treated crack surfaces are cleaned you can layer it by adding more new strips and heating/reheating this material in the cracks even after several months. In many cases I also cut these strips into small segments of an inch or less in many of the smaller cracks and it spreads out and runs down into the cracks. Note, it cuts more easily after leaving in the sun for 20 or more minutes. It's a lot of work if you have many cracks but I knew that going-in after reading reviews. I'm happy with it so far after almost a year and 1 winter.

We need to wait a year to see if this holds up. I will say it seems solid, way better than the liquid crack fix you will find at Home Depot or Lowes. I had to remove that junk to repair with this stuff. Buy a flexible hose for your torch, it makes it much easier.

I tried many different products to fill some cracks in my asphalt driveway. Nothing works anywhere near as well as this stuff. The really nice thing is touching it up again after the crack starts coming back. Nothing you do will stop the cracks from re-appearing. With this all you need to do is hit it again with a hand torch and add some more to it. One piece of advice, don't try to lay it on the crack or push it into the crack and torch it, you'll most likely burn your driveway. Instead, hold it up carefully and melt it over the crack. It will turn to liquid and run into the cracks. Yes, you will need to be careful not to get the melted stuff on you.

Had kind of a learning curve to get it right but came out great. Had in-between size cracks so sometimes I used my small torch and melted it like a welding rod into the crack and then used a putty knife to smooth and fully fill the crack. Looks good but can't speak to the durability yet.

Very misleading title & description. Title say it is 60ft.. (2 pack) and it shows a picture of 2 packs. It makes buyers think that they are buying 2 packs of 60ft each. But in reality you are only get 30ft x2. Nowhere in the title or description says it is 30ft each box.