310A Pro/Tran2 30-Amp 10-Circuit 2 Manual Transfer Switch with Optional Power Inlet

Great price..excellent panel box..

Purchased from Jasper Generators on Amazon on September 12 and had it on September 19. Relatively easy install thanks to Reliance’s step by step YouTube videos. Would have taken about an hour if my box would not have been recessed into the wall. I have not had a chance to run it with the generator yet but will update my review later if need be. Living in Florida I wanted an easy and safe way to use my generator. This switched seemed like a no brainer. I did change out the double twenty breaker to a double 30 to match my main AC unit. The 310A allows for the breaker change way easier than the older model 31410.

Very good product! Excellent instructions by Reliance on YouTube on how to install. I had one issue that took a while to resolve. Once set up and tested it kept knocking off one breaker. I checked and double checked everything again. Everything was set up properly. I went to the computer and found a post where someone had the same issue. He had a wire not connected by the factory behind the circuit breakers. I took the face plate off in front of the breakers and sure enough, one wire had not been connected by the factory. A very easy fix that caused a long delay and much frustrating. So, take the face plate off that covers the breakers and check the wiring before you install.Quality product! Would have given this 5 stars had it not been for this issue.

Great product and works as expected.

After running a number of extension cords during our last power outage I decided I'd get this for next time.Installation - My breaker panel is in the garage so installing this next to it was easy. The flexible conduit is only about 18", but the wire leads were long enough to reach the upper breakers in my panel.The breakers in the transfer switch are standard. #1&2 are 30A, the rest come equipped with 15A breakers. The manual states that 20A are supported so I swapped a couple to match my main panel. The switch also comes with two (2) tie-bars for double-pole (220V) circuits.The individual transfer switches feel solid with definite detents in all three positions (Generator, Off, Line).My generator would not support a full load on all circuits so it's nice that I can monitor the load and toggle circuits on or off depending on needs.

It is great. I purchased on advice of electrician that set it up so I can use my generator in the event of a power outage. It very easy to use and lets me select circuits/appliances to turn on within the limits of my generator.

Great works great thanks

Nicely made panel. I flush mounted it into an existing drywall covered wall. I wish the panel’s exterior top mounting bracket was removable as it makes it difficult to flush mount. The circuit identification on the wire pairs is a huge improvement over the old labels!