Bora Portamate PM-3795 Mobile Base & Table Saw Extension Combo

This mobile baee is built with some heavy duty steel. The frame is very rigid and is going to be great for my table saw. I have no concerns about it's durability. It's easy to move around within my workshop. The only issue I ran into was a missing flange but for one of the wheels. Luckily was able to get one at Lowe's.

I got a new cabinet (fancy table) saw from Harvey for the holidays. I ordered this base to move it around. The platform went together in about 30 minutes it was assembled. With some help from friends, we put the saw on the base. Now three months later the saw has been moved in to the work position and back to storage a number of times, the base is very easy to roll (I do it alone), it is solid under the saw and the quality of cuts is as good as the initial cuts I made before putting the saw on the base. Likely I will order one for my lathe and maybe a couple more for other tools. Highly recommended.

Seems to be very heavduty andell made but just did not fit mŷ sàw. Had tobreturn it vecause did not fit!

I WOULD HAVE GIVEN THIS A 5 STARS BUT THE CASTORS ON THE EXTENSION ARE TERRIBLE. THE CASTORS ON THE EXTENSION DO NOT WANT TO SWIVEL SO EVERYTIME YOU TRY TO MOVE THE TABLE THEY GET STUCK AND WON'T LET YOU GO WHERE YOU WANT TO GO.

I searched for a mobile base for my 1984 10” Sears Craftsman TableSaw in preparation for a new Incra TS LS-32 saw fence system and legs supports I have on order, I wanted a heavy duty base with a base extension to also handle the legs supports for the fence and this is a perfect match the Bora Portamate PM-3795 Combo includes the Base Extension, the seller shipped it quickly and it arrived with no damages it was box perfect and the inside contents were packed excellent from Bora Portamate with a great installation books, it is well made top quality materials heavy duty steel including all hardware needed the operation is # 1 very smooth you can move the saw with 1 finger the casters are top quality and it raises and lowers very easy. It not the cheapest but you get what you pay for.

Product is pretty heavy duty with mostly decent welds. This is good because mine arrived in a jumble in the bottom of the box. Tons of scratches and cosmetic damage. Also missing hardware due to the loose pieces tearing holes in the box. Update- after using product a few times, do not buy with the fence extension under any circumstances and do not buy at all if your floors are not perfectly smooth. Wheels cannot handle any roughness to floor. Single tie in point of extension causes the table leg support to tip so the stopper drags and allows it to flop all over. The extension has flopped around to the point it has broken my jet extension table. Dealing with Bora customer service is also poor. Lesson learned- weld my own product.

I used it on a table saw that's 620 lbs and has a 52" extension with legs. I was worried that it wouldn't range that far but had room leftover. You want to take some care on the layout as you can put the wheels different ways and the instructions aren't super helpful but it came packed logically. I think you should knock off points for quality not speed of shipment or instructions that really aren't product related. Anyway, look at the images that match how you want the product layout paying attention to the wheels then assemble it that way. For the stop that rotates down you want to put washers on the inside. The closest one is easy but the one on the other side (see picture) requires a little bit of dexterity. Use a piece of wire to help the washer from falling down.

Unit wasn’t difficult to assemble and works great on my heavy vintage Rockwell saw. The all direction casters are great. I should have done this sooner.