PLA Filament 1.75mm, 3D Printing Filament, PLA Filament 1.75mm for 3D Printer, Precisione Dimension +/- 0.03mm, 1kg 1 Spool (2.2 LBS), Black

For the price you can't really grumble. I had to adjust my normal profile for this filament, lowering the speed by 10ms/s else I got some delamination but that mostly sorted it out. It's fine filament. I will say the spools centre hole is large so on my machine it has a habit of coming off the spool holder, but that could be specific to just me, wedge it place and all is fine

All good, recommend!

Got off to a disappointing start. Not the best wound filament. But was pleasantly surprised with the finish. Had a small issue with stringing. But a nice product

Great filament and the reel will last ages. My perfect print temperature is 230 degrees at the nozzle and 65 degrees at the base.It's a strong plastic and can be used for structural builds.

After reading the reviews for this filament I thought I'd give it a try. My first impressions were good. Temp tower turned out clean and smooth with a nice shine and minimum stringing. So I carried out a small print to fully dial my settings in and I was impressed. At 230 nozzle and 70 bed I got a really nice result. I then decided to use it on a project I am currently working on based on my initial results. All went well until the second print on the project when I returned from my lunch to find a mess. The filament had a rather nasty tangle on the spool and had caused a failure. So I removed the spool and began to wind it over onto a spare spool to make sure this wouldn't happen again. This was when the reality of the problem began to dawn on me. In order to rewind this spool I had to spend nearly an hour removing tangles and winding the filament between two posts placed at either end of my 35ft workshop then wind it all back onto a spool. This was quite honestly the most tangled spool I have ever received in all the years I have been 3D printing. I'm hoping this was an isolated case and I just got a bad spool but with modern production methods things like this shouldn't happen. I may purchase another spool just to check whether this was a one off as I hope but I am dissapointed this has happened hence the three star overall rating of my review.

This filament is PETG+ although there is no information about what the + refers to but itdoes not have the shiny surface of other PETG fiiaments and has a finish closer to PLA. It printed well with few strings at 220 degrees but I found that it warped badly when the bed temperature was not close to the stated 90 degrees so for later prints I also used sugar solution on the bed to help adhesion. I had one large print fail due to the winding being poor when a tangle stopped the filament feeding into my Ender 5. Therefore I only feel confident to use this when I am able to constantly monitor the print progress. This might be a bad batch - I have only bought the one reel and if it was well wound I would buy it again so I will consider trying a second time.

Prints really well, overhangs are good. Printed on ender 3s1, at 220C, bed temp 70c, 60 m/s, no part cooling.