120V Dimmable LED Strip Light, Work with Smart Plug, Waterproof IP65, No Need LED Driver Converter, Cool White 6000K Flexible LED Rope Light, 110 Volt Kitchen Light, 115V Under Cabinet LED Light

The media could not be loaded. No driver needed, just the LED light strip. Bright as core of the sun, and dimmable using a stock Lutron LED dimmer, which is available in all stores. Dimmable from your wall switch. You can cut the strip every few inches. The only weak link in this system is that they currently don't make a connector that fits on a cut end. I cut off both connectors and hard wired to romex that i ran to each cabinet run. I don't know how to solder, but i was able to jury-rig a connection using "Solderless Snap Down 2Pin Conductor LED Strip Connector for 8mm Wide 3528 2835 Single Color Flex LED Strips". These connectors are too narrow, but i cut it in half, and secure with hot glue, which allowed me to make it work.

It was rather difficult to find these and most say 120v then have a wall-wart or other adapter, remotes and all that stupid crap you really don't need for a 'built-in' job. I used small sections of these on the upper inside edges of some custom cabinets and cut up some cheap white extension cords to solder in for power to each. These are hard-wired behind the cabinet to a wall dimmer and they work great! (Lutron Diva dimmer). The go from a light glow at the low end to very bright on full. The strip can be cut about every foot which is perfect for adding custom 'highlights' around a room. You can solder 120V directly to the strand section to install.

Nice that this LED strip can run on 110v and doesn’t need a transformer/stepdown.

Very bright but we had to buy 3m adehisive tape to get it to stick

Still working after one year

It's very bright and very good quality.

They are bright. Tape is no good.

I never got the remote

Exactly what I was looking for.

Very bright , dimming works great , easy to install

I routered a 3/4" wide groove into the bottom of my cupboards, 1/4" deep. These lights fit in perfect, and easy to cut to length (at 4" intervals) Be sure to cut where indicated.If you are mounting under cupboards, and going around a 90 degree corner, leave at least 6" space between the lights, or you will end up with a "Bright Spot"I soldered 22 AWG Bell wire (commonly used in garage door opener sensor, garage door opener doorbell button application)The wire is thin enough to hide under the cupboards, drill and hide up through the inside cupboard corners, and is firm enough to drill and fish through behind drywall.I have the wires strung into a 110v Leviton LED compatible Dimmer switch.The lights themselves work great, but the 2 sided tape is horrible. I ended up using contact cement to hold these lights in place.They work great if you are handy.