YUNBO LED Strip Light Warm White 3000-3500K, 16.4ft/5M 300 Units Cuttable SMD 5050 24V Waterproof Flexible LED Tape Light for Home, Kitchen Cabinet, Living Room Lighting Decoration

Quality lights for the price.

Purchased in Aug 2021, operate approximately 6 hours a day. Sections of the strip stopped working after 12 months. By Oct 2023, less than 5,000 hours of operation, 4 sections of a 36" strip were not working. Really not acceptable when LEDs should last 50,000 hours. Additionally, the provided adhesive was inadequate, I had to hot glue the strip to get it to stay in place.

The media could not be loaded.  I applied back to my fire place and looks amazing

I used these lights to install with a door switch to allow lighting up a spice cabinet instead of having to turn on the overhead lighting at night. Decided to also replace the old undercounter xenon lighting, as the heat from the lights would melt semi-sweet chocolates among other things. The positives are ease of install of connectors to the strip lighting, as long as you have the right connectors. The supplied adhesive is worthless, so make sure you have mechanical fasteners or good 3M double sided tape.... or both! The brightness is good but the color (k) is rated to low. My guess is the 3000-3500 is over 4000k and the 4000-4500 is way over 5000k. But overall, I am happy. The attached picture is with the supposed, 3000-3500k LEDs. You decide.

I used this behind crown molding as an indirect light. It has a good white, not bluish light, and the brightness is range is very acceptable.

My largest complaint is that the "natural white" is absolutely cool/daylight white. So I'd go with the warm if you want natural, and the natural if you want cool. I can't imagine how blue the actual cool temp strips are. The lights are bright and seem of decent quality but the adhesive strip peels completely away if you're not careful to only lift the blue strip, not that it's very useful anyways. The adhesive isn't sticky.

I bought this LED strip to run off of an extra 24V power supply I had laying around and I hooked it up trusting that what was advertised is what I would receive. Well, after a few months of occasional use, half of the LED strip is visibly discolored and I am now noticing that the LEDs are uncomfortably warm. I looked closer at the strip and it CLEARLY says 12V all over the strip -- a similar 5V strip that I purchased says 5V all over, and a different 24V strip that I purchased says 24V all over.THESE ARE NOT 24V LEDS. Completely unacceptable.

Used these to replace some undercabinet lights in the kitchen. The original LED strips were brighter. I ended up doubling up a couple critical sections, like over 2' stretch over a prep sink, where they were more seriously underperforming. I had enough in the package to take care of that, and enough power supply capacity for the added load, so no serious issues.If you are expecting these to match an existing installation of different brand, use care.Yes, the new product has the same color temperature rating (3000-3500K) as the ones I am replacing. Supply voltage is correct too.mrs dr bob will decide if they come out for a product that more closely matches the 8yo LED strips that were in there. The Good News is that they are inexpensive and fairly quick and easy to change.

Da applicare con trasformatore 24v !! L'adesivo non è un granché. Le luci sono coperte da una striscia di gel. Possono essere tagliate ogni 15cm circa. Da una estremità della striscia c'è un jack dall'altra 2 fili elettrici in modo da poter essere collegata direttamente all'interno del trasformatore.Le luci sono potenti e freddissime. Infatti sono circa 6500 kelvin. praticamente azzurrine. Sono molto soddisfatto.

Nutze die LED Kette als Ersatz Leuchtmittel für mein Garagentor (braucht 24V). Schöne helles Licht, sehr gleichmäßig. Nur die Klebefunktion ist unterirdisch. Da muss man mit alternativ Kleber nachhelfen, ansonsten hält da nichts.

Very good

Ottimo prodotto, luce molto luminosa

The led lights are great but the adhesive is really really poorDoest stick even with wiping the surface with alcohol firstObviously letting it dry