Vehicle CB Mobile Radio Antenna Mirror Mount Bumper Roof Rack Pole Mount Fixed Bracket for Car Truck CB/VHF UHF/Ham/Amateur Mobile Radio Antenna SO239 Female Connector

Used this for my weboost antenna so I could have it go up and down. Had to drill bigger holes and the screws that come with it don’t fit in the prinsu rack channel (too small). However, after some modification it does the job well. Hopefully lasts over time.

Installed on roof rack rail. Hinge that allows antenna to move failed on first outing.

Mounting did not allow the antenna to be verticle

I needed a foldover mount for my antenna so that I could get my car into the garage. I put an NMO mount connector on it and had to open the hole to accept the NMO connector. I also added a Panavise magnet to the base of the mount so that it would also be a mag mount and I could remove it when ever I wanted to. Now I can use a 5/8 wave antenna for 2 meters and enjoy the added gain of the antenna. On today's antennas, foleover is the way to go if you have a garage.

I am using this antenna mount with a WeBoost antenna with the short extension (short extension is needed to get enough separation of the internal and external antennas), cable exit tube and spring. When the antenna is extended, the mount flexes before the spring. I need a folding antenna mount so I can get my car into the garage and this looks like the only viable solution on Amazon with a tube mount. I am afraid once I go off road with the antenna extended, the mount will flex until it breaks.

I got this thing to mount a Weboost OTR antenna to the back of my RV,I only use the antenna when the rig is stopped so I wanted to be able to fold in down for traveling.The material is very thin, so thin that I had to get a thick washer just to be able to mount the spring for my antenna.The plastic knob that adjusts the angle, is made of very fragile plastic. It's since been replaced with a metal thumbscrew and a wingnut to back it up, I also used a fender washer and large neoprene washer just to make sure it doesn't move when I don't want it to.I knew what I was getting when I got this, and for my use it's just going to be ok, if you have a taller or heavier antenna, pass on this thing.

I am returning this before even trying to install it. It's too thin and weak for my WeBoost antenna. It might be ok for stereo antenna or something like that on-road but not for my application.

It will get the job done. Angle lock is weak

Not a good product. You can't tighten the screws enough to keep it from falling down.I used blue thread lock on it too!!I mounted a Weboost Range omni antenna with the 13" pole to it.I even left out the spring mount to save weight.

These are very lightweight, I would not recommend using anything over a 24" antenna & nothing heavyduty! The plastic knobs look great but don't hold well, possibly loc tite them as well as the mount bolts. 2 stripped during my install but I pushed them honestly & they are good mounts just very light duty.

I like this set up. Seemed to be the best of all the Antenna mounts I've seen. I like it cuz it's not spot specific ... comes with every possible mounting option, so even if you decide to move it later, then your covered. Pretty sturdy to.