1 Pair Photoelectric Sensor M18 Infrared Ray Through-Beam Reflection

I'm not used to things working better than they claim. Running both ends at +12V DC, this Tx-Rx set worked all the way out to 51 feet, which is 15 meters. (That was the limit; it didn't work beyond that.) They only advertise a 5 meter range, so that is 3x better than the spec. Pointing accuracy at both ends was critical, of course, at that range. I notice it draws more current at higher voltage, so I'm guessing range would drop if you only run 6V instead of 12V. Both ends have a visible red LED. The transmitter side LED is always on, while the receiver side LED is on only when the beam is NOT detected.

I use this photo sensor in my cage/trap and it works great.

The range is far greater than 5m. The model number suggests max of 18 meters. I am using it for 10 meters and there are no probs. Like most of the inexpensive thru beam sensor sets, it will not operate a mechanical relay. Use a relay with hi lo level and set it for low level trigger. Brown wire to positive, blue to negative and black to relay trigger. Do not expect decent documentation.

Like? - Price! Purpose? - In a manufacturing automation environment. Stacking parts on conveyor belt verification. Also, stopping machine function if beam is interrupted etc. On third set, and third usage and they're all working perfectly.

I'm using this to trigger some Halloween decoration special effects in front of my house. For those curious, I measured current draw of just the beam side, and with a supply voltage of ~ 8V it only draws ~ 3mA. If supply voltage increases to e.g. 16V then current draw goes up to ~ 6mA. I wanted to know what this is because I plan on hiding the beam and want to power it with (4) 18650 LiIon batteries connected in series. So this should work well given the fact that I can easily expect to get a few hundred hours of beam time before typical 18650 batteries are depleted.

I used this to make an invisible crossing detector. The pair triggers an alarm when a line is crossed. The product works as advertised and seems to be rugged.

Just worked 1 hour

Alignment matters! Seemed defective after 8 months, but sensors needed to be realigned. Back and working again!

aucun commentaire.

These were to be used for an automatic chicken door, unfortunately the proximity single is not designed to operate a mechanical relay, it’s more suited for a signal response rather then a control. The manufacturer was little help unfortunately.