Atlas Scientific Whitebox T3 for Raspberry Pi

I find the T3 to be very easy to setup and use. I plan to purchase more as I expand.

I purchased the Tentacle T3 direct from Atlas Scientific 2 years ago with BNC connectors. I used the EZO Ph and EZO RTD. After 3 months I could no longer receive readings. It was like the board wasn't connected to the Pi. I never touched anything, didn't even update the raspberry Pi software. I tested the EZO circuits and probes without the Tentacle and they worked. Rebuilt Raspberry Pi software, tried a different Rapsberry Pi, hours later same failure results.Because I spent so much on the probes I thought I would give it another chance. Purchased a new Tentacle T3 direct from Whitebox Labs this time, but they had the SMA connectors. Connect up new Tentacle T3 to same old Raspberry Pi 4 board I was using and software. All works. Proves the older board from 2 years ago failed. Go to put the Pi and Tentacle in the case I purchased specifically from Whitebox Labs for this configuration. Screw connectors onto the EZO RTD all fine. Screw the connector onto the 3rd postion EZO spot for the Ph probe, it barely hits the edge of the plastic but this is enough to completly pull the SMA connector off of the Tentacle T3 board!!!! It looks like the SMAs are barely glued onto the board....... Angry now. Get out super glue and glue the SMA connector back to the main Tentacle T3 board. Ok it works again... 3 hours later though my Ph readings are completely unreliable, guessing the super glue came undone. Now I have to take it all back apart and try to glue the SMA connector back to the Tentacle board. Knowing this POS board will fail and break again.COMPLETE WASTE OF MONEY!!!! Total rip off. I'm out $200 plus for garbage. I'm going to use an ESP8266 with the EZO boards on my own circuit. Never again with Whitebox Lab Tentacle boards, JUNK.