Pressure switch for air compressor made by Furnas / Hubbell 69JF7LY2C 95-125 Four port w/ unloader & on/off lever

I've had this installed and in use for almost 5 months now without a single issue. It replaced a worn out one on my 25+ year old Sandborn 11 gallon compressor. I needed the low profile, and this worked out perfectly. No leaks. NOTE: I had to rotate the bottom to make it work on my Sandborn. Else the orientation would have been wrong. I was able to rotate it without issue, applying pressure where needed (or maybe not?) to prevent spring deployment...again - no issues doing that.

mucho

It was very easy to install and after testing, it consistently work with exceptional accuracy. It is certainly worth every dollar that it cost. Thank you. 🤠

This has been pressurized for a few months now and no leaks. Runs flawless. I replaced my oiled 20 gallon horizontal porter cable switch that was discontinued. I’m very pleased

It's a very nice switch... working well. But, I think the bottom port was tapped off center... or I cross-threaded it. I'm skeptical of the latter. It does not leak

Update: after reading another review with low stars/rating, and a little research, i suspected the problem could be with my compressor check valve. Bought a direct replacement check valve for my 20 y/o Husky 6.5 HP 60 Gal. Tank, and that fixed the unloaded valve leaking problem. If your unloaded valve suddenly starts leaking, it’s most likely your check valve. Replace this $10 part first, it’s easier.Everything came as expected, was a direct replacement for my OEM Husky 6.5 HP 60 Gal. Tank. Will have to change motor terminals out, but that’s easy.Only problem is the unOrder valve leaks, this pressure switch is worthless, should have saved and hour (now two) and put a more expensive switch for a higher probability it would work. Buyer Beware

Unit works well, but as is often the case with Hubbell, it is a bit overpriced compared to alternative sources.

After careful research to make sure the pressure switch matched the original on my compressor I purchased the part with the usual ease, using Amazon. The connections on the switch were able to be adjusted to meet the placement of air lines. The only issue was with the electrical terminals which had to be slightly modified to have a safe secure connection. Successfully installed and the compressor is back in business.