for 2005-2013 Chevrolet Corvette C6 All Models | ZR1 Style Rear Trunk Lid Wing Spoiler with Hardware Included (ABS Plastic - Hydro-Dipped Carbon Fiber)

Carbon ZR1 spoiler looked amazing on my AO Z06. Very affordable, quality looks very good, and packaged nicely. I drilled and attached mine as I knew it was never coming off. Masking tape on the bumper cover, grease or Vaseline on the studs of the spoiler to mark the locations, drill and done. Total install took maybe 1hr. I did have to clearance the connector for the 3rd brake light some. That could have been the light itself or the spoiler I don't know which as it was a new light.

I feel that the price for this is really good. The install is easy and straight forward. The nice thing is the center piece is a direct bolt on with the original nub spoiler that comes on the C6. If you aren't sure if you are going to like it permanently, it's easy to bolt down the middle and drive around to see if you like it. If you do, you can then go ahead and do a more permanent install. The fact that it is ABS means the plastic will hold up well and be easy to deal with down the line.Came with all the needed hardware, simple instructions, and a good price. I dig it. There were a few very small plastic hangs that I lightly razor shaved, but with any plastic mold that is to be expected. nothing bad or flawed, good quality.

Looks good out of the box. Fit car good. Had to drill some holes but that was not a big deal. Check you tube for instructional videos. Looks very good mounted on car. Only been install about a week and have not had into sun to see if it warps but I dont think it will.

Just with the sheer packaging it beats every other imitator of the product. Great price doesn’t weight anything at all ,comes with the hardware, and the packaging down to a T. I have bought some others but ran into problems of it seemingly being stepped on or crushed every time it arrived but! With these fine folk they make sure it’s sent out with some decent protection ! Still have to get it fitted but will post a pick after!If you need the low profile zr1 look? Then this is the spoiler you need! Nice sleek and subtle look but not overtly excessive as some others.

Not as advertised, supposedly "carbon fiber look" looks more like hounds tooth than carbon fiber, print was more grayish than black. Spoiler came intact and undamaged, but was not worth the asking price IMHO, upon returning was hit with a 20% "restocking fee" of over $50 !!! Don't waste your money buyer beware.

Excellent look to the tail end of any vette.The 4 original spoiler holes line up perfectly; the 6 holes that need to be drilled (3 on each side of center)…. Can be challenging to for some to get right. Take your time measure many times and drill once.Great price, look and addition

Great looking spoiler that really completes the backend. I combined the install with a set of Amerilite LED halo taillights. Added a nice modern touch to my 2005 Corvette.

Exellent value easy to install.