MEPRO Tru-Dot tritium Night Sights Compatible with S&W M&P Green tritium dots Glow on Sight self Illuminated Meprolight Fixed Metal high Durability Sights

Excellent budget sight. Israeli made, easy to drill hole. Just take your time. Lights up well in pure darkness.

I purchased these in January of 2016, and it's now December 2023 - eight years later.They are tritium, so they're not as bright as they were when new, but they're still at least twice as bright as any of my non-tritium sights after five minutes in the dark, even when I "charge" the others with a powerful flashlight beforehand.The fit is fine - they're sights, so it's not like I expected intricate machining; they're exactly the dimensions they should be and have held zero through the ~5k rounds I've put throough that pistol since they were installed. The finish applied to these is matte, and shows "scuffs" fairly easily, but it has held up just fine. I keep that pistol in a leather OWB holster; the rear sight is exposed and the front sight contacts the inside of the holster. There is no apparent wear on either.I plan to do some testing in the near future to compare the brightness of my eight-year-old sights with a brand new set in both the visible and IR spectrums - I'll try to remember to update this review with those results.Bottom line: this was a great purchase for me, and I remain 100% satisfied with them.

This set of Tritium sights is much better than the Night Fission and Tru Glo sights I recently bought.I just bought a TruGlo set from an Ebay seller that was dim and hard to see in daylight. These sights have a bigger white ring around the rear and front glow tubes, they are brighter in the dark.Makes it much easier to see down range.

Easily installed, and improved accuracy and night visibility. Rear sight slid right on the S&W 10mm, but could not endure the 10mm pounding. Came loose and fell off-- somewhere. Used Loctite on set screw, but fit was just too loose. Would still buy again because material is of very high quality, but it would take some serious professional gunsmithing to keep the sights on 10mm.

I used a sight pusher to remove the factory front sight. I put the Meprolight sight in the freezer for an hour then using a brass punch and a hammer easily installed it. The white dot on the Meprolight is sized perfectly for the factory rear sights which i did not replace. Its an added bonus that the sight glows bright green when the lights are out. These sights are excellent and a great economical upgrade to the Bodyguard.

I purchased these sites for my S&W M&P 9mm about a year ago and loved them. So I purchased a second set for my wife's identical S&W M&P 9mm. I paid a professional gunsmith to install the sites. After bringing the gun back home, I realized the front site was not glowing anywhere near as bright as the rear sites, less than 20%. I contacted the seller, Primary Arms. They referred me to "The MAKO Group" (Meprolight). They sent me an RMA and indicated that I had to remove the sites, send them back to them, then they would send me a replacement if they agreed with my assessment. I was not happy with that arrangement so I contacted Primary Arms and explained the situation. However, they indicated that I had no other choice but to either go along with The Mako Group requirement, or, remove the sites, return them to Primary Arms, they would give me a refund, and I would have to place another order.In my opinion, they should send me another front site only and then allow me to return the defective front site. But instead, I now have to take the gun back to the gunsmith, have him remove the defective sites, ($20.00) install my OLD sites, send the defective sites back, place another order, and HOPE the new sites are not defective, take the gun BACK to the gunsmith and pay ANOTHER $20.00 to have the replacement sites installed.This is not acceptable to me, so I will be returning the defective sites and hope I get my money back. And then, start over and try to find a company that will stand behind their product and do the right thing for their customers. So just now, that if you do business here and are unfortunate enough to receive a defective product, you too will have to jump through hoops of fire in order to get the matter resolved. So bottom line, the night sites are awesome, when they work.

I looked everywhere for a tritium sight and decided on this one. Way more cost friendly than the competition but at the same keeping up with quality. Pay attention that mepro says this sight is for a sigma "v" series pistol. When I tell you that this was a drop in and loctite replacement sight for a SW40VE I am speeking the truth. Sight fit perfect and looks great! I did not have to do any filing at all for fitment. The sight has less drift than the stock and is easily acquired. Im actually shooting better groups and my poa is correct with my poi. In low light conditions the glow is noticeable and in the dark is surprisingly very bright! I am now searching for meprolight sights for my remaining armament. Take time to measure your center and go slow. Loctite 609 is recommended to fasten the sights. Just remember a little of that stuff, and I do mean a little, goes a very long way.