Idatalink ADS-USB Weblink USB Interface

Works exactly as it should. Used it immediately with a cm7200 and blade-al. No issues. Also used it with a FLCAN module I had on the shelf, worked great.

its a usb cable for a remote start system and it worked, so ya its alright but i wish they just used a regular usb for it no need for the this special cable in today.

Worked great. Used to program DC3 Remote start module.

I used this to install the Firstech FT-DC3-HC in a 2016 Honda Odyssey with the ADS-THR-HA10 T-Harness.For anyone doing this setup, the PCU is over the gas pedal but it's up and towards the center of the vehicle. I found it easier to remove the bracket holding the two separate units that are directly over the gas pedal, then removing the bracket that holds the PCU.You will need to remove the steering column shroud to hook up the horn, and parking light wires. There are 3 phillips screws on the bottom side, and two behind the steering wheel. I was able to turn the wheel 90 degrees in each direction to remove them.There is no need to hookup the hood switch. I'm assuming the signal is passed along by the T-Harness. I originally had tapped into the factory hood sensor and it was giving me an error. Without that wire hooked up the engine still cuts off if pop the hood while it's in remote start mode.Before hooking the DC3 up to the vehicle plug it into your computer and go to https://www.idatalink.com/weblink/ in internet explorer. It will download an add on then let you flash it. I had a firmware update then I picked which vehicle I was hooking it up to. After that you can plug it into the vehicle do the first steps. Then plug it into the computer to finish programming. After that you plug it back in the vehicle and finish the last few steps.For mine I found I am able to open the lift gate once the vehicle was started remotely but I can't remote open the sliding doors. I programmed mine to have a 5 minute delay between opening the drivers door and having to close it and pus the brake and start button.I just installed it yesterday so no additional tips.

Works as it's suppose to.

Cable was fairly easy to use with the dc3, had no issues whats so ever. 5/5

It isn’t communicating with my computer and I’ve been struggling to get ahold of idatalink tech support to figure out what’s going on. If it’s not too late I’m probably going to return it.

Worked as advertised. Had to do some basic youtube research. Definitely a must have if you’re installing a compustar remote start.