Hornady Cam Lock Bullet Puller 050095 - Reloading Equipment to Quickly Pull Bullets with Your Press - Save Your Bullets, Brass, & Powder for Future Loading - Uses Standard Collets (Sold Separately)

Worked perfectly when used with proper collet size to remove bullet in great condition and save powder too

I've been reloading for years and never knew this product existed. As soon as I heard about it, I purchased it. It takes just a few minutes to setup properly but once its set, it is the perfect tool. No more of the impact hammer and powder flying all over the place!

A necessary tool. Especially if you have a lapse of concentration and screw up your reloads!! It is so easy to use and it works like magic.

Works a lot better than my kinetic bullet puller.

This thing is awesome. If anyone was ever reloaded on a progressive press and you mess up a few hundred rounds. This is the one to have. Real time saver.

I have tried others but this is an awesome tool.

It replaced the old one that locked up after decade of use. Plunger stuck in old one. Can't complain about the use I got from it. Pulled many thousands of bullets.

I would add the most common collets like 223, 243 and 308 when ordering. This works a lot better than a gravity hammer to remove bullets.

Tricky to start with but once you get the knack it is fast, no damage to heads, and Powder is neatly saved.

Empfehlung

This is a great piece of kit, you need to also purchase the appropriate calibre size collet. This is far quicker and less fiddly than a kinetic bullet 'hammer' type puller.

It has been a great help, once I set it properly for my reloaded 6.5 Creedmore rounds. For longer ammunition, you cannot set it by the directions. You need to set it so the bullet just enters the collet and the casing is just below. Hold the ram in this position, and close the handle on the Bullet Puller then lower the ram to remove the bullet.

great piece of kit,