Snailfly Silver Crossbars Fit for KIA Telluride 2019-2022 Cross Bar Roof Rack with Lock

Here they are in the picture holding a Thule Cargo Box. We drove from NJ to FL and back without issue at speed.No issues with them at all. The reviews claiming they do not fit must not have been mechanically inclined people or their particular set was a problem. Once you adjust the screws and pull or push the ends to where you need them you'll have no problem fitting these to your Telluride.

They were hard to lock in place but once in place they were pretty sturdy.

It is very difficult to install the plastic plates with the lock. Was not able to install one at all.

It fit but not very adjustable up and down the tracks. The rails are to wide. It held up well on a 1500 mile trip.

Same story as most reviews. Bought these bars in early 2021 for my 2020 EX. Small bar fit fine in the rear. Front one didn’t begin to fit until over the sunroof about 6” from the front. Way too far fwd. Very noticeable vibe/noise that I didn’t adjust and drive enough to find a better fit. Passed my return date so I’m stuck with these. So busted out the hacksaw and shaved off a worthless 1.5” from the front bar. Now I can fit it way back behind the sunroof and I’m able to crank it tight onto the rails. Just haven’t retested it yet alone or with a basket to check noise and vibe.

I absolutely love my purchase! The look of the roof racks I adore. I’m a 27yr old female & I installed this within 2-2.5 hours by myself. It wouldn’t have taken that long if I had an extra hand which I do suggest. I was very hesitant to purchase after reading mostly bad reviews but just decided to try. They fit perfectly! Although the instructions were worthless. That’s the only bad thing. Also, I paid less than $150 for these whereas if I were to purchase from the dealer & paid for installment it would have been $600+. If your contemplating purchasing, MAKE THE PURCHASE! Lol

Bought for a 2020 Telluride SX. Being “universal “, the cross bars don’t fit snugly. Terrible installation instructions poorly transcribed, lacked adequate detail. The plastic end covers don’t fit at all and leave large gaps on the leading edge, which will capture air and eventually break. They noticeably vibrate/resonate at speeds 35-45mph. Not thrilled with these, shouldn’t have tried to do it on the cheap.

Bars fit on our 2020 Telluride as described. You MUST pull up the top rubber seal on the bars and loosen the allen screws to adjust the bars wider for the front of the vehicle. Then once you have it in place, tighten all 3 screws per side, 6 total per bar: 2 on top, one on the side. Seem to be good quality and strong. We are going on a 1,000+ mile trip soon so I will update if anything changes. Over all I am happy with the purchase!