Steel DN Mate 40 Pack T316 Stainless Steel Right&Left Handed Thread Swage Lag Screws for Wood Post of 1/8 Steel Cable Railing Kit, Cable Railing Hardware, DIY Wood Baluster, Wrench Included DM20

Update. We installed these on Fresh PT 4x4. Over the past month as the PT has dried, it shrunk and there isnt enough tension on the lag threads and they are all backing their way out. Otherwise, I stand by the old notes. Don’t fall for the suggestion of getting a harbor freight crimper. These are very easy to use, we put them in a hand chuck drill for fast starting and left about quarter of an inch on each side of an 18’ run and they sunk to the perfect spot when tightened to proper tension. (Depending how accurate your rope cut was. We did find the tightening tool to be hard to use almost worthless when the wire spacing is only 3” apart so we had to improvise. We made our own jig for consistent placement and predrill depth. BE CAREFUL ON CORNERS! We were too accurate in our consistency and centering causing the bolts to run into each other and unable to be tightened further

Two armatures that have never done any cable railing before. We did take our time and I did pre-mark and use string to visualize before we started (which I highly recommend). This also helped me decide to make the cable 5” apart vs 4” which I am glad I did. These were East to install and we used a hydraulic crimper to place 2 crimps. It has a very tight hold on the cable.

I did a lot of research via amazon, you tube, web sites, hardware stores (e.g. Menards, Lowes, etc) and decided to go with this product design and was VERY happy that I did. Not only was this hardware significantly more economical in price vs other designs on the market, it is also one of the least noticeable to look at (more appealing visually) as well as one of the easiest to install. My deck has standard 90 degree angles, however has a few 30 degree angles as well. Simply drilling holes into the 4x4 at that angle made these very easy to install and adjust.Lastly, there customer service stood behind the product. I purchased several bulk packages. Was missing one. They stepped up to the plate and quickly sent additional components. Prompt and professional. Highly recommend this hardware attachment company and product.

I ordered 12 sets of these drawer slides to re-build a set of kitchen cabinets.The pros- very easy to install. One measurement on the drawer to install the drawer section, then the cabinet section installs at the bottom of the drawer opening.Cons- they were not packaged well. There was room in the shipping box for them to slide around. This allowed them to puncture both the cardboard box, and little baggie holding the screws. Several of the screws were missing and I had to pick up some more from the hardware store. One set even slid around so much ghat the ball bearings were dislodged. I returned and replaced that one.They seem well made and hopefully they are durable.

Easy to install. Directions in the product description make sense. Seems a little pricey compared to other screws, but they work well.

got this because I wanted to make a cable railing system and not spend money in a "kit" from a brick and mortar. They're crazy easy to use and have kept their finish thus far in the rain and sunshine.

After researching the best method for converting my deck railing to cable about a year ago I decided I wasn’t ready for the project. When I came back to the research recently, these were available and looked MUCH simpler and cheaper. Installation was easy and the look is exactly as I hoped!

Product was reasonably easy to install as long as you have a hydraulic crimped tool. I used it to create a ladder for cloning roses to attach to on the sides of my arbor.