(C800906) 10 Foam Bonnet

Yes it is a tight fit but be careful and works great. I just put one end on my 10" orbital buffer then carefully stretched the rest over the pad. It takes a little time but in a couple of minutes a perfect fit. My black truck turned out beautiful as it removed all the fine scratches seen in direct light. I will be ordering another one as a backup at this low price

Worked perfect on my 10" Harbor Freight Orbital Buffer. Was able to wax an entire car without even breaking a sweat. Followed the advice of some of the product reviews to be careful with regards to stretching and tearing to get this on though since it is very tight going on, but didn't have any issues and it held up for the most part.

I bought 4 of these. The first two tore right off the get go! Bought two more and no problems. Got the job done!

Not sure what other reviewers mean when they say this is low quality. Not quite sure what more they would want. I used this on my Ryobi portable 10" buffer and although they're a little tough to get on (which is more of a good thing than bad), they were perfectly fine for wax and polish applications for my cars.

This foam bonnet is one of the best out there at an affordable price.

Tight fit and will only last a few full uses, BUT if you are cleaning up an old paint job and gonna hit it with a couple buffing rounds with compound etc this will work like a champ. I used it on a very neglected 4Runner paint that was prob never waxed in its life being a 2006. This worked great with maguires ultimate compound. From oxidation and flat to glossy.

Worked fine, was careful to stretch onto a 10" buffer and had no rips. Not as fragile in my opinion as long as you take your time.

Seems to be the same as the original that came with the buffer. Sturdy foam, fit the buffer perfectly and works.4 stars, cause you've gotta leave room for improvement, right?

This didn’t last one time before it ripped apart.