CNC Laser Engraving Machine DIY Engraver Desktop Wood Router/Cutter/Printer + Laser Goggles Working Area 300x400mm 2 Axis (2500MW)

 I went with this engraver as a step into laser engraving/cutting and have been pleasantly surprised. I had been contemplating adding a similar diode to one of my 3D printers but this setup is roughly the same cost. It has been working well with wood and cutting cardboard so far, but I have not tried much past that yet. I am excited to see what else I can engrave and this will probably end up getting me to purchase a larger cutter in the future.NOTE: make sure to wear the safety goggles at all times for safety

The entire instructions came on 1 page printed on a printer that is almost out of ink. I was not mentally prepared for this one. Finally got it mostly together then there are no more instructions but I still have the belts and cabling to go. I guessed on both. Plug it into laptop. Red light when plugged into usb. Nothing else. Rummaged through included usb stick, but no more instructions. Found the jpg of the printout. Found engraving software, but no connection. Can't find any support anything for this. Very frustrating.Update: It moves, but without instructions on how to operate it, not sure what to do. If seller does not provide instructions I will have to return.

The machine works like a charm and looks good however the instructions were poor but nothing a little puzzle solving can't fix.