Turntable Motor for Panasonic F63265G60AP F63265G60CP Microwave Synchronous Motor NNSD987S NN-SD987S etc

Our 10 year old Panasonic microwave NNSN661S started acting up recently. The turntable was slow to start and made groaning noises. Food was not cooking evenly because of this issue. I thought we had to replace the microwave. A web search revealed that the turntable motors do fail and it is a fairly easy fix. Motor received quickly. Unplugged microwave. Removed the glass dish and roller ring. Gently pried the plastic shaft guide. Flipped microwave over. There should be a panel door. (Our door had to be snipped with a pair diagonal pliers.). Removed the access panel door. (Be careful of sharp edges from the snipping. unplug the two leads. Remove one Philips screw holding the motor. Twist and remove motor. Replace motor and reverse instructions. ( I needed a machine screw to reattach the panel). Voila, microwave is now as good as new!

I bought is as a replacement for the Panasonic motor that stopped working. Was simple to install: one screw and 2 jacks. No need to replace the microwave! Very pleased!

This motor has been in use for several months and continues to function. My only complaint is that it does not rotate a single revolution in 10 seconds, it’s slightly off. After about 3 minutes the tray is behind by half revolution. The original was spot on ! Don’t allow food particles to get under the tray and block rotation, that will damage plastic gears inside as the motor fights to overcome the obstacle.

As other reviewer said, the motor shaft is way too thick for the microwave fit at least in Emersen microwave. To be able to make it fit, the shaft needed to be sliced off to reduce the width. Apart from that it works fine and only time will tell how many years it will last. I wish company works on shaft design after conducting research on models it promotes for as a replacement motor.

Purchased for Cuisinart CMW-100, the platter stopped spinning. I knew it was the motor because I could rotate the shaft freely. This type of motor should be locked in place until electricity is supplied. As mentioned, you'll need to file down the D-shaft on the motor. The flat side needs some filing, but I also needed to reduce the overall shaft diameter to get it to fit into the coupler. I did this with 100 grit sandpaper, carefully. I got it to the point where the coupler would snap into the shaft very securely, which I found also improved the noise of the microwave while operating, it used to rattle a little bit. If you want to fix your Microwave for under $15, this is a pretty solid bet. For installation, you will need a T15 Security bit, which has an indentation in the bit to allow for the pin in the center of the screws that are used on the bezel. Everything else about disassembly is straightforward. I recommend leaning the MW onto it's left side, where the transformer is located. It is heavy, and this way you can just sort of "open" the bottom cover with enough access to replace the platter motor, like a trap door. Also, the motor is reversible, so the red/yellow wires don't necessarily need to go back into the original positions.

My microwave was screaming 😱 for help and wouldn’t turn with any weight on it. After a little research I ordered a new part seeing how it’s only snipping the bottom mount, undo the electrical tabs, unscrew one screw. Out with the old and in with the new and everything in reverse order. You can flip the bottom mount around and there are slots to put it in and hole for an additional metal screw I had in my garage. The microwave is quiet 🤐 as a mouse 🐭 and spins like a dancer 💃.

Worked good was right part

Works great. Could not get a replacement from Toshiba. They gave us a full refund -$150 and suggested I go to Amazon and buy a motor for $15- so I did. Easy to install.

J'avais peur que le moteur expédié soit différent de l'illustration mais finalement c'est exactement le bon. La livraison a été plutôt longue (17 jours) et le «tracking» impossible mais j'ai enfin reçu le moteur hier, installé sans peine ce matin et tout fonctionne parfaitement! Notons que ces pièces sont pas mal chères, considérant le prix d'un micro-ondes neuf mais c'est un petit geste pour diminuer l'encombrement des déchetteries.

Descripción e imagen idénticas al producto, funciona a la perfeccion

Brought life back to my microwave

Panasonic Microwave original motor was defective what else could you say! Came in a nice little box!

Fits Panasonic, wish it came with turntable coupler. I had to file plastic shaft, so it would fit my coupler; otherwise 5 stars. Unit works well and turntable noise is now gone.