DC 80mm Fan 24V 8015 Dual Ball Bearing Brushless Cooling 80mmx15mm 2PIN (Pack of 2Pcs)

Great fans, use one of them to replace the fan in my ender k1 max

They work and the price was good. Had to repin the polarity for the application but it worked.

Bought this to replace the fan on an anycubic vyper printer. Size wise it's a perfect fit however in the pictures of the fan they never show the other side of the fan. It has a recess on in my case on the side that mates to the cover. The blind thread inserts fit into this recess making the screws to long for mounting (the screws provided were of a different type) as they would bottom out. Not a big deal but I would have purchase a different fan had I known. Ended up putting a washer between the fan and thread insert which works fine so far. Overall noise wise I did notice any difference from the stock fan and yes I would buy again if it was not for the recess.

Nice fan, good and strong. I hope to get a long life from the ball bearing. Ended up being louder than I had hoped but that is due mainly to proximity of heatsink. This is running to cool down the hot side of a small peliter-based medication cooler known as "The Baller Fridge". Original fan started getting loud after a few months and this is test #1 of fan replacment.

I purchased this to replace the stock main board cooling fan on my Sovol SV08 printer. The stock fan is much smaller and was very loud even when the printer wasn't printing. This fan, combined with a mount I found on Printables solved that problem and the machine is silent while not printing and much quieter during operation.

Included screws are so wide they split the fan case when you torque them down and so short they don't extend through the fan to attach anything.

Not much else to add. They are right size and work exactly as I had hoped. Replaced a bad fan from a laptop chiller pad.

Smooth operation, quiet, and good air flow. Used for ventilation rather than cooling, but great product for a good price

Great value for money easy to install very quiet and cool like there supposed to will buy again when I need

Ventola di raffreddamento installata sulla scheda madre di una stampante 3d, ottima, poco rumorosa, con un'efficienza di tutto rispetto.

Purchased this fan to reduce noise level of stock fan. Turns out this one is same or little more noisy than stock. Also there is an effect on the prints especially PETG would dry sooner as the air flows into the chamber of Anycubic Kobra S1

Tut seinen Job, gut verpackt und schlank. Allerdings ist der Lüfter viel lauter als angegeben, fast 20db mehr!

Sehr gut geeignet als leise 12 V Lüfter.