🏁 Unleash the Beast Within Your Corvette!
The SR1 Performance C6 & C7 Lowering Bolts are engineered to enhance both the performance and appearance of your 2005-2014 Corvette. This set of four bolts allows for a lowering of up to 2.5 inches, improving handling and reducing body roll, while giving your vehicle an aggressive edge.
| Brand | SR1 Performance |
| Item Weight | 1.04 pounds |
| Package Dimensions | 3.58 x 3.54 x 2.17 inches |
| Item model number | 33131000 |
| Is Discontinued By Manufacturer | No |
| Manufacturer Part Number | 33131000 |
O**S
Works
Installed on my C6. Easy PZ. 1) remove wheels 2) unbolt and remove shocks 3) unbolt upper control arm ball joint 4) let a-arm assembly hang, careful of the abs sensor wiring (unplug) and brake line 4) unscrew old spring bolt and pull from bottom of spring. You might need to push down on the a-arm assembly a little. Install is reverse. Then get an alignment! Love how easy it is on corvettes to lower.My originals were sheared in half some how, but I never noticed it and the ride height never changed.
J**
That's these bolts are Amazing
They made the job easier on my 2007 chevrolet corvette
G**I
Perfect ride height, 10/10 initial impressions
These lowering bolts paired with bilstein b8 have improved the look and handling tremendously. Great improvement over stock! Photos show the lowering bolts at their lowest setting.
C**E
Let’s see
Took a hole saw to a hockey puck and countersunk this into it to get a replica of the stock item. Saved a couple of hundred dollars. I would have had to purchase an entire spring assembly to get the part. Just another stab in the back courtesy of GM / Corvette.
M**T
Cheapest way to lower your Vette!
It did the job it was said to do. Very easy, straight forward install.
T**E
The broken side went on just fine, but the other side would not screw in
I had to get these to replace a broken stock one. The broken side went on just fine, but the other side would not screw in. These are .3mm larger than the stock ones, or at least the stock one in my cars right rear. I had to buy a 14mm X 2.00 Tap to run through the nut in the spring. Either way, giving this 5 stars because it was probably GM's quality more than the actual product (I tested both on a 14mm x 2.00 nut and both went on fine).
K**R
Needed the drivability
Changed the car
C**E
Like OEM while lowering your car the right way.
These things are amazing for the price I've bought more expensive versions which were terrible and made noise these are as close as you're going to get to OEM while lowering your car the right way.
Trustpilot
3 weeks ago
1 month ago
