JoyTutus High Lift Tube Mount with Gasket for 2"-3.3" Tube, Spare Tire Adjustable Jack Tube Mount Bracket with Gasket for Wrangler Roof Rack Front Bumper Bull Bar Roll Cage

These are sturdy mounts. They were easy to install and fit around my large front bull bar. The security mechanism is simple, but hopefully effective. I have tested it out on a 200 mile off road adventure. Everything stayed tight and secure.

Very strong and quality built equipment, I used to mount a high lift jack to my 2021 Polaris RZR Turbo S. Highly recommended!

The piece of rubber that comes with it to stop from scratching the bull bar was much to thin and tore. I had to purchase a thicker piece. Easy to install. Holds well.

This set of brackets is absolutely perfect for my Hi-Lift 5 foot jack. I was able to mount my jack onto the brush guard of my Hummer, and it looked fabulous once mounted there... Been driving with it mounted for about 4 weeks now, and experienced zero problems. Stays put, and the 2 rubber padding straps prevent the brackets from scratching my brush guard.

Mounted It to the tire carrier on my Xrc Atlas rear bumper behind the tire at 45 degrees angle, clears the back on my jeep and seems to have a solid mount on it, only thing I am iffy on is the detent screws to lock into place when the bolts to the jack are screwed in.

I lost a bolt and they were incredibly responsive, solving the problem straight away. The mounts themselves have done a perfect job of holding my High Lift jack in place despite some rough trails. I wish these folks ran the customer service departments of a few other companies! I highly recommend.

I installed the mounts, decided to change the location and the nuts were frozen. Turns out the threads had stripped and I was unable to remove them. Had to cut them with a grinder. I would not recommend purchasing, spend the extra money and buy a higher quality product cause this isn't it.

These will not work on roll bars in an 08 JKU with Bestop slantback Sunrider. Not blaming it on the product, of course, just informing. If they go on the roll bars near the tailgate they're too far apart for a 48" Hi-Lift and a 60" Hi-Lift won't even fit in the Jeep sideways. I've thought about putting them on the upper rear bar but there's plastic over the rollbars and no room with the slantback cover anyway. I'll keep 'em around in case I get a front bull bar since that's what these were intended for. >.<