Replacement Fireplace Blower Kit for Heat-N-Glo, Hearth and Home, Quadra Fire, GTI, Heatilator, Majestic, Superior, Monessen, Vermont Castings Fireplace, GFK-160A GFK-160 FAB-1600 Fireplace Blower Kit

Very easy to install. The temp sensor has a magnetic bracket which I placed in the middle near where the igniter and gas go up. Takes about 6 minutes before the fan turns on and about 15 to turn off. It’s also very quiet. I’ve had gas fireplaces in the past and this fan is quieter than any I’ve heard.

I have a Heat & Glow 6000 gas fireplace. I installed this blower about a week ago and it works very well. As the description stated, this is a very tight fit, but it does fit. I needed to remove the rubber feet and remove the glass, but it finally made it. Wiring diagram could be a little cleared, but it was adequate

Installed well. All sensors work well. Just a little louder than I was hoping but it probably reasonable.

Great product. Easy to fit as long as you have access to an outlet. I do have to take the glass of the front of the fire insert to make room to install but it wasn’t difficult.

Jotul wants $550 for blower that is pretty much the same as this. Quick easy setup. Works as well as Jotul unit & has about the same noise level. Big savings!

This blower was added to an existing 20 year old gas fireplace we refaced during extensive home remodel. The fireplace now warms the open concept 2 story area where we spend the majority of our time. A great product!

1. There is a very loud hum coming from motor. The video doesn’t represent this well. It’s VERY loud. 2. As stated elsewhere, the wires do not come configured correctly. You will have to remove the ground eyelet replacing it with a spade connector. The instructions show the ground connected in this way. This wouldn’t be an issue if the motor had been quieter.

Installed in our fireplace and works well