RoadSport 5602 Large Size 'B' 3.25" x 37.0" Rear Bumper Protector

This was purchased for a 2007 VW Rabbit 2 door. The manufacturer states that this fits "2 and 4 door VW golfs".... which are the same bodyshell as the rabbit. This bumper cover does not fit the Rabbit at all.... the radius is totally wrong. As the cover is firm plastic, it won't bend width-wise to accommodate the difference, and its not possible to trim the cover because of where the double stick tape is located.This cover is sold as a generic fit for several cars, but because its firm plastic, if it doesn't happen to be the perfect shape for your particular car, its not going to adapt or modify easily to make it fit. The finish on the cover was reasonable, not cheap looking.... but it wasn't trimmed very well on the edges.... I would have cleaned it up with a razor knife prior to fitting it.

Easy to install if you take your time and use painters tape or similar to mark your spot for install. It looks like it belongs on the car, and so far it's staying put. It makes me more confident to haul things in and out of the back of my vehicle and the bumper stays scratch free.

Looked good on my daughters 2010 Pontiac Vibe. Covered some scratches that were there when we obtained the vehicle.Easy to install. We originally bought the A, its very small, not sure what it will fit well since this car is already very small, so returned it for the B which was much better

Ok, but not what I needed. Needing something to cover the edge of the bumper. This was not sufficient.

I was looking for this for my new 2015 Nissan Rogue. I researched many sites and even called a Nissan parts dealer to find out they don't make one yet for the 2015 models. Then I found this, and it fits quite well. It does not cover the entire back bumper but does offer a lot of coverage, with some overlapping under the lift gate, but the lift gate has no problem closing. I am hoping that the tape stays (I applied correctly by putting even pressure along the length then using a roll of duct tape to smooth it out) but if it does not hold I will just apply some new 3M tape. It will still be cheaper than OEM and will cover all the scratches that I didn't even realize could happen so easily. So far, would definitely recommend!

Good product if it fits your car but even though it says it fits my car on the packaging, the curve is WAY off, so much so that the area that needs most protection isn't covered at all. My 2014 ford explorer has a much more curved bumper, product is too straight and too short (but i knew it would be short).

It fits my 2015 honda crv just fine, just need to adjust the position here and there a little bit.Good quality materials.

Installed with ease but would have liked a longer one for my '15 CRV