3Pcs Decapping Pin

The ZOEKIM 3Pcs Decapping Pin set is a solid replacement for the Lee 90783/90292 Universal Decap Die. They fit properly, install easily, and function exactly as expected. I’ve been using them primarily for 9mm, and they decap smoothly without any issues.

Works very well. Absolutely no breaking of pins whatsoever when properly used. If you break a pin it is 100% that it wasn’t lined up correctly.

Used these in my Lee de-capping die. So far the first one is holding up way better than the Lee pin that came with the die. I believe this might be because the tips are slightly tapered? I’ve already taken primers out of over 500 military 5.56 cases. (Crimped style)

I broke my decapping rod in my Lee classic reloaded kit. These three were cheaper than one OEM replacement and they are stronger also

After several years my Lee universal decapper pin broke. I used the original pin to prep thousands of cases, including swaged/sealed military ammo. While searching for a replacement I found these. As you can see in the pictures they're clearly not hardened. After 400+/- large rifle shells some swaged/sealed complete failure of the pins. Two are bent, one broke off, maybe low grade tool steel that's not hardened. They're also painted so resetting the height is required as they slip as the paint comes off. Zero stars, but it doesn't work.

Well made replacement De-capping pins for Lee Sizing/De-capping dies.

First, I'll say I was slightly disappointed that the tip got stuck in the first few cases testing these in a Frankford Arsenal hand deprimer. I then spun the pins in a drill against a piece of sandpaper using deprimed cases as a gauge to reduce the taper just enough until the cases didn't get stuck anymore. Now they work beautifully! I used to have trouble with Blazer brass not fully pushing the primers out and the anvil getting stuck on the pin. But now with these new pins every primer is being removed. I almost decided to stop processing Blazer brass because of the issue, but now my frustration is over. The stem measures .202 and they fit perfectly in the lee decapping die collet. So they must have addressed the issue I've read in a few other reviews. So even though I did have to rework the tips, I am giving these 5 stars for solving the Blazer brass issue.

Not as tough as I thought they would be.

Works great. Fits all lee dies (or at least the ones I have). Cheaper then buying from cabelas once you consider shipping and quite solid. If you’re burning through these it’s worth it.

I damaged my Lee Loader decapper on its first outing. I forgot to remove the cap from under the decapping cartridge holder and bent the pin (which snapped off as I straightened it). I ordered these to replace it and they have worked fine, more resilient than the Lee Loader original tool. I suspect I will need three, it looks as if decapping is a stressful exercise :-)

These decapping pins are undersized and keep slipping in the decapper clamp unless the decapper clamp is tightened down with extreme force. Factory original parts are 0.205" in diameter and these are 0.199" in diameter. That may not seem like much but it makes a big difference. These decapping pins have a tapered point which enlarges the flash hole if it isn't adjusted just right. Too long and it stretches the flash hole, too short and the primer doesn't drop free. Overall they aren't worth the money. I should have bought the proper replacement part from Lee Precision.