Deflecto Semi Rigid Aluminum Duct with Attached Connectors, Silver, 4" x 24" (MAC36024/6)

I bought this because I keep my dryer closer to the wall in the laundry room and other ones way too long causing bends. Well-made and durable and went on easily for the vent going outside but a tight fit for the dryer so I used my own clamps. It does not come with clamps! 👍🏼 I recommend this

I have 2 and I'm fixing to buy 2 more for my grow tents. The bottom 1 - intake - has a 90 deg up bend followed by a 90 deg horizontal bend. Extend the tube past where you need it to terminate or start a new bend. As you lift up on the free end - give yourself plenty of extra length, you'll need it - slowly pleat the inside of the bend back to it's starting point. It's not complicated if you go slow. Not snail slow, but "I'm being careful" slow. The top fan needs a 90 deg bend down to stop any light from entering. That was super easy after doing the first one. Last tip: Yes, it's "fragile", but if you haven't capped the end with a filter, like I did on the first one, you can reach in and smooth out any creases before they cause a problem. Luckily, the little crease on the first one doesn't bother me - am I'm anal retentive. Sound too complicated for you? Grow a pair.

Good and strong vent tube, but 24" is it's fully expanded length. It says that on the packaging you get, but not in the description. I thought I was buying some semi-rigid stuff I had bought before that started off 24" and expanded from there.

Instead of elbow+straight duct out the side in LG dryer conversion kit, which required tearing the dryer apart & removing the drum because the ribs on their elbow piece wouldn’t fit thru the 4.5” dia back and side vent holes, this flexible hose w/swivel connectors fit through the holes! No demolition- just used 2 hands through the back & side holes to install this flexible hose with foil tape. Had to be careful not to crush the flexible hose, or poke through the foil, but it worked well.

This did a good enough job, but it bent a bit during install - it didn't break, and it should work well enough until I need to clean out my duct pipe again, but it seems like they could improve the strength a bit without making it much more expensive.But, I am happy to be rid of the Dryer Dragon, and this was a cheap way to do that.

ok

Nice concept, terrible design and execution. It tore apart as I attempted to stretch it according to its design and use. I bought a second one but plan on returning it and going with something else.

This is a very sturdy aluminum duct that is much better than the common flimsy aluminum ducts that you would typically use to connect your dryer. It was easy to install over my dryer opening as well as to the existing duct in the wall. I have a relatively straight connections from dryer to wall outlet but the duct is strong but bendable if you need it to go through a more challenging connection.