ANTOCarburetor #30 for Kohler K321 K341 K361 14HP 16HP Engines 47 853 30-S

Carb was a good fit. I had to work with the bolts to snug them down. Really tight between the bolt head and carburetor body

If you can install this on the intended Kohler engine you can install this on the Tecumseh.I had to re route the choke and adjust the governor spring, but I will never again put a carb kit in a walbro carb if this is still able to be bought. It was silly simple to install.Now my 30+ year old Bolens tractors (yep, I bought one for two different OH160 powered tractors once I discovered it was so simple to make them dependable again) are finally easy to use. They start with the first revolution it seems. they stay running. They use no extra fuel. they do not overheat, they do not smoke black from too much fuel. They simply run perfect! For the first time in years. Why did I wait so long?

Works fine other then the choke works backwords if hooked up

Bought a mower with a bad carb so I bought this carb to replace it. Installed it and I should have returned it right away but I did not. The low idle screw did nothing when setting the carb. Now the engine floods no matter the setting on either the idle or high speed screws. Opened the bowl and everything looks clean and good yet the needle and seat are not controlling the fuel flow. Ran ok for a bit and then acted up. Now fuel runs out without shutting off. Seat is clean and needle seats good until the fuel pump (2-4 lbs pressure) puts fuel to it.

Was a exact fit for a kohler 14hp on a yard tractor replaced fuel pump too. Starts like a new tractor and idles!!

The old bolts did not fit in the threads to hold the air filter on, and I didn't receive any for this order. When I got some bolts that seemed right, 1 fit in one of the holes, and they were the same size bolts! But I guess it works alright for now.

I received two choke shaft with places to hook the choke cable into both were wrong and would not work with my cub cadet, I had to take end off of one choke shaft and turn it 180 degrees and then weld it back onvery disappointed in this not fit problem, did not receive a gasket for the air filter to carburetor, have 3 same model cub cadets, but would not order this one again

Carburetor And all included were fine. Problem with manufacturer of spare choke shaft the flat for the butterfly is milled on the wrong side of the shaft. You can make this work, but beware of it.

This carb had ALL the correct parts already attached for my specific application (choke arm & throttle fulcrum). But also included were other arms and brackets for other choke and throttle uses for those who needed it. After installing the carb and the new hoses/filter, all I needed to do was prime engine with some gas thru the plug hole and behold, it started and actually began idling nice and smooth instantaneously. A bit of a turn here and there from my initial 1 1/2 turns on the mix needles and it was good to go. Thanks.