Overpeak 10 inch Circular Saw Blade, 80 Tooth ATB Finishing Saw Blades with 5/8-Inch Arbor, Laser-Cut Thin Kerf and Anti-Rust Coating

Just put it on the Saw yesterday, which was Friday and it seems to be flat and working very good as far as longevity. I can’t answer that at this time but it seems to work good thank you, if this product is as good as it starts out, the be I sure will be looking for them in the future. Thank you.

Searching for a high tooth finishing blade to cut pre-finished MDF base and crown but not wanting to spend $50, I ran across this profuct and read the reviews. Absolutely worth the money! Cuts like butter and doesn’t leave a single knick.Cuts both upright and flat with ease. Like with any trim cut, wait for the break to engage and the blade to stop before moving your wood. I hate reading bad reviews of a product left by someone who blames the blade when it’s really their poor technique.Product: Finished EleganceTool: Dewalt 10” miter single tilt

good value for the money

Have bought 10 and 12 in Overpeak blades; this is first for the 7 1/4 in. Very sharp teeth, as sharp or sharper than the 30 dollar blades. This 40 tooth blade makes a fine cut with very little tear out. Use my fingers to sooth the tiny splinters off the cut. Really wish Overpeak made this blade in a 60 tooth version. Recommend to all miter saw owners.

Bought two of these recently and they cut very well. Used on my mitre saw to cut 3/4” plywood and pine. No issues. Cuts like butter. We’ll see how long they last, but for now, I think it was a good buy for the price.

These blades are inexpensive and get the job done.

Good balance bladeStays sharpCuts very smooth

As far as the compound miter saw goes, this blade cuts with minimal tearing/splintering on hard and soft wood. I expect it to perform similarly on the table saw, but will update this if anything is different. There is some blue stain from the blade that is left on the cut surface - I will see if this decreases after use.