10W SMA Attenuator,40db,DC to 3GHz,50 Ohm

Excellent lower power attenuators allowing the output of 10Watt transmitters to be reduced to a level that permits the attenuator output to be connected to a receiver or spectrum analyzer at a low enough level to avoid damage. It's bulky and heavy, though much less so than a 100W model. It should reduce the transmitter output by two orders of magnitude, 0.05Watts from a 5Watt source. It helps to have lower power cascaded "tuning" attenuators to adjust as necessary. You probably shouldn't hang it on a handy-talky (HT) as it's weight isn't something the HT is designed to have on the antenna connector. So, best used on a flat surface.Any heat from the attenuation will be distributed through the built-in heatsink. It would be best to use with a little care on surfaces but 10 Watts and the circular heatsink should mean not much heat transfers even during long transmissions. It's useful to have a variety of short connector cables to attach to other devices, this has SMA male input and SMA female output.

A great product good solid engine engineering. I’m sure it will last a lifetime.

perfect, works great, within specs.

I was fairly impressed with this dummy load while using it to load my radios while evaluating signal output for spurious harmonics. I didn't identify anything abnormally produced between the signal while sinking it with the load or loading a regular antenna. Worthwhile product to have on hand.

Thus far, it works fine for me with me Seesii TinySA. Will know more in a couple of months.

arrived on time...good shape

I don't know that I trust these for higher frequencies or 10W outputs, but for VHF and low UHF these are great for testing your average 5W HT. Make sure you have enough attenuation to not overload your analyzer (not just enough to get below the limit).

Worked well with the test equipment I bought to check emissions of my handhelds.

Handy for testing HT's

Sembra ben fatto , corrisponde a quanto dichiarato come attenuazione, swr, resistenza. Lo utilizzo con un uBitx che non eroga piu di 10 watt, ma quando è bruciato ero sui 20mt, dove non eroga più di 6 watt, dopo pochi minuti si è interrotto presentando una resistenza infinita.

Ein erforderlich und nützliches Produkt, Dummy Load damit das zu messende Gerát funktionsfähig bleibt. Das Teil ist gut, leider nicht günstig. Größere Funken, sollte man nich damit testen. 73

Not much to say other than they work.

checked out allright but haven't yet tested the 10W they claim