Small Parts 1020KWTF Steel Self-Drilling Screw, Zinc Plated Finish, Wafer Head, Star Drive, #3 Drill Point, #10-16 Thread Size, 1-1/4" Length (Pack of 50)

Great Product! Fast Shipping! Recommend Seller!

When I was looking for a self tapping screws.The seller sites all said for wood, not intended for metal. They looked like any other self tapping screws I’ve used. I removed a section of floor from a boat. It was originally install with blind rivets. I decided to used screw to reinstall the floor for future access. These screws had the flat head I needed. If they won’t drill metal I can drill pilot holes. When I receive the screws they looked like they would drill metal. I used a 3/16” piece of steel. I used a lower speed because my thinking was when the threads reached the metal the screw might snap. As the picture shows it work just fine. I’m mounting wood to aluminum. Notice, I had the 3/16” steel mounted in a vice for safety.

I will say this much…do not use cheap torx bits.The torx indentation is somewhat shallow…plus being the material these screws are made from..cheap bits will not grab the screws well plus cheapo bits will strip out fast.After buying quality torxs bit these screws performed far better though you’ll still need to put pressure straight forward on the screw heads.The drill edges work..but not 100% reliable.Yes..I’d buy these again because of quantity…I needed a lot of these screws. And performance is acceptable when using quality torx bits as noted.

Worked well for constructing the gate

Would buy again

Money wasted. These had a hard time drilling into 1/16” mild steel. Some that made it through, ended up breaking. They are also T20 torc, but every T20 bit I had fit very loose in them. I’ll keep them around for very soft sheet metal or plastic.

The torks head is not standard size T-20 is loose and T-25 too big difficult to drive straight. About 1/3 of the screw ends are defective and have flaws that make them difficult to run. Overall not very good. I used them but had to pre drill 16 gauge metal and fight the wobble.

This screw fits a torx bit very well without flopping around and it pierced 1/8" steel without much trouble.