Samurai Kurobushi Spray Paint 2K #2K01H- PU TOP COAT CLEAR HIGH GLOSS (D-I-Y Do It Yourself)- 400ml, Transparent Glossy Finish

Don't hesitate to buy the other reviews talk abt orange peel effect which can be prevented by immersing the can in warm waterI used this product on a moped and I have to say that it's mind blowing. Gave a glossy finish and was more than enough to cover all the parts and bodyFollow these steps:1. Wash, clean and dry the surface then sand your existing layer of paint with 120 and 220 grit sandpapers. Wash it off and let it dry.2. Spray your primer coats.3. Let the primer dry for 2hrs and wet sand lightly with 400 grit sandpaper. Clean the dust off.4. Spray your base coat and let it dry for 30 mins5. Before activating the clear coat immerse the can in a mug with the warmest tap water available this increases the can pressure and prevents orange peel effect in the clear coat. Activate the can, shake it and spray evenly with a good distance from the surface.6. When you are done don't touch the surface for atleast 2 days. You can wetsand with 2000 grit and apply polish after 7 days.

Good Product, But while spraying spray was not painting uniformly on surface, it was adding bubbles.

Or else everything is ok

Don't waste your money and time, this 2K Top Coat will ruin the surface you are about to paint, all the hard work and effort you put for the painting preparation will be wasted, The spray from the can is uneven and it sprays a foggy like thing. Don't waste your money, I was lucky because it was returnable, but now they have stopped return and replacement for this product.

It does not work with enamel paint. And when I tried to mix by pressing the bottom red cap all the hardner came out over my clothes and legs.... Now I have to repaint everything 🥲🥲🥲

Very durable and thick , heat and scratch resistant. here few tips for you1) wash the area with soap/shampoo, dry it then apply rubbing alcohol to remove any grease/dust.2) make sure you have plenty of light, try to spray during mid day so you can see the the amount of spray.3) make sure the place is dust free.4) keep the spray bottle not less than 15cm away, it will form thick and runny(once u make a mess it will be difficult to remove so keep it in mind)5) once you open the spray u finish it, meaning you should not reuse it after. So prepare all your spray parts all and spray all of them once u engage the spray.6) finish the spray within 30minutes. The longer you taking to spray the stickier it gets.7) if you need time before each spray clean the nozzle with alcohol after end of spray.Takes whole day to dry, once spray done keep it in non dusty area, just let it air dry. Try not to touch the paint while its drying it will leave fingerprint marks.Hope it helps .Cheers.

In Indian conditions it dries causes cracks flaking. Used it on headlights

The Quality of product, Ease of use, Spray pattern, Finish is all good.But be careful... i tried to paint a second coat after allowing curing of first coat for a day and it completly ruined the finish, lots of wrinkling and the lower layer started to loosen, fold and go bad as if i have sprayed paint stripper.I had to entirely strip the paint and start fresh. next time i will do only one coat.