🚀 Unleash Your Creativity with Dual Extrusion!
The Dual Color 2 in 2 Out Extruder is a 12V, 40W hotend kit designed for 3D printers using 1.75mm filament. It features a dual extrusion system with individually adjustable nozzles and independent temperature control, allowing for versatile material use and precise printing.
A**R
Didnt work on my setup but wished it would have liked the style
Didn't work on my setup
L**N
Doesn't come with any way to mount without creating something
No instructions, mounting screws, or plates. No template to help design something. To mount to.
G**R
Soft Metal, expected of a knockoff of a knockoff
Its the cheapest chimera out there that I could find, it actually is what I ordered for that price.Now the issue comes with the fact that the screws used to hold the throat were easily stripped, causing me to use all 4 spots, and even then the left hotend throat didn't stay in all the way, it wiggles easily. The nozzle and throat easily screw and unscrew each other. If the block is held in place and I twist the throat the nozzle unscrews some. I haven't printed with it yet but it seems to be overall acceptable in condition and build.I'm using a direct drive on the right, Bowden on the left. I'm hoping this will workout. I'm running it on my Ender 3 mod.Overall only use this if its in an enclosed and undisturbed spot on the hotend carriage and it should be safe. No hard bumps to the hotend.
J**T
Jams, Jams, Jams, Jams, Jams, Jams and SCREWS NOT ON SIDE LIKE IN PICTURE
Item arrived. It looked ok at first other than the hotend set screws are on the back instead of the sides like the picture shows. Installed the unit, and was VERY IMPRESSED that it actually has all metal hotends. But there's a problem. The Unit is misaligned internally, so it gets JAMMED all the time. And heres the problem. It works for a few seconds, but after the 1st "retraction" when it goes to put filament back in, it can't. And it get jammed in a part with no heat, so it literally has no way to get past it. This requires pulling out the filament, cutting it off, and reinstalling it. I've tired rebuilding this thing several times, all with the same result. The one i received is just misaligned internally, and can't be fixed by me.. I'm just sending it back and will get a mixing nozzle this time i guess...I really only wanted to print PVA dissolvable filament for support.. :(
U**O
The grubscrews are on the back, and not on the side.
Finishing seems fine, the components seem good. However, I bought thinking it would be one design (the grubscrews that control the nozzle height) being on the side, but it is in the back.
Trustpilot
1 month ago
1 month ago
