Hubbell-Raco 809C 4" 2 Gfi Receptacle Cover

I did get raised metal duplex Decora covers, but they didn't have the clean stampings shown in the illustration, but ones with snap-off tabs tapped to accept mounting screws. Mebbe good for bottom line, but definitely not what I wanted.

The fault lies with me for not paying attention. These covers are for 4" boxes; standard size is 4.5".If you are looking actually looking for a 4", this is a quality product.

Make sure to trim the metal mounting straps all the way to the wide hole with metal scissors. This is the one you will use to attach it to screw and nut.

Plate is well made, heavy steel. Installation is time consuming but that is a result of the box size, not a fault of this cover. Installing two GFCI's requires: 1) breaking off the tabs on the GFCI's to fit the cover 2) wiring at least one of them up before installing in the plate, then 3) installing the wired GFCI into the plate with 2 screws. You can't access the terminal screws (or pressure plate screws) of a 20A GFCI one installed on the plate. If you have a choice, you are better to go with one GFCI per box, but in my situation that wasn't a good option.

Couldn’t find these at any box store. Product came quickly and works as designed.

These are oddly hard to find at the big box stores near me - I have some older basement plugs and wanted to upgrade them - these fit perfectly.

This comes with all the hardware to install 2 decora outlets in one 4 inch metal box. I can't find these anywhere at the local hardware stores, as they only are carrying the single outlet covers.

Good finish. No jagged edges. Fits recepticles well, and comes with 4 screws and nuts to secure the recepticles to the faceplate. You can't go wrong with this.