10'' inch Black Slim Fan Push Pull Electric Radiator Cooling 12V 80w 800 CFM Mount Kit Universal (Black)

Remove and apply loctite to every nut or screw, including the fanblade nut. They will all back out while in use and fall out, if used on a motorcycle due to vibration. Being made of plastic, torquing down hardware will break it. Loctite allows light torque on hardware and keeps everything intact.

works better than factory one .

Good

I bought this fan to build a “redneck air conditioner” to use on our pontoon boat. In the photo, there is tape around the hole I cut in the cooler, but it’s not to hold the fan in place. There are screw holes that are perfect for mounting the fan. I reversed the fan blade, and reversed the wire polarity so that it would blow down into the cooler. The fan does this job very well, and keeps my wife cool. It makes a little more noise than would be ideal, but not so much as to be annoying. After all, it was designed to be under the hood of a vehicle! Puts out plenty of air, and does its job. Just one point to add: if you do this, make sure you have a second battery on your boat. You don’t want to try starting your engine after being anchored for a while to find you ran your battery has run down!

Got this to provide air circulation for trans cooler being used to cool a small high pressure air compressor used for Pcp rifles. Had to purchase a power converter to use it but all together makes a great system

Removed mechanical viscous fan on 98 Jeep Cherokee and installed this as primary fan. Super thin and slides right in with room to spare. Wired to auxiliary switch and auxiliary thermostat. Little large for my radiator so I had to fabricate a cover for exposed area hanging below radiator. Pulls strong air though through radiator, a/c condenser and aftermarket trans cooler. Works flawlessly and holds 4.0 liter between 170 - 190 degrees and trans just a little warmer no matter speed. Make sure you order correct size for your need. I highly recommend this fan.

It beats spending $600 at the dealer and 2 of the factor bolts lined up and it was plug and play for the 2015 Kawasaki 4010 mule kaf620. I did have to use one of the thru zip ties on the bottom though.

Blows air and is reversible. Nice