Jasco Bix EJBP00206 Premium Paint &amp Epoxy Remover, 17 oz

Wow. This stuff is POWERFULL! It truly does remove all enamel and epoxy based paints, and right away! On contact the paint begins to bubble and lift off. All you need after that is to either gently scrape or wipe the melted paint off. Works great!

If you need it to remove a 2 stage automotive paint, it will do it. I had some base coat/clear coat paint on some chrome tail pipes for the last 15 years. As you can imagine, it was pretty baked on. I had tried scrapping it off but nothing would touch it. I sprayed this stuff on, waited 7 minutes and was able to brush the now gooey paint off the tailpipes with a piece of foam. It came off like warm butter. I then just did a little clean up with a rag. It was pretty scary how easily it came off actually. It made me glad I listened to the instructions and covered up my quarter panels with plastic before I attempted the job.

I don't often fuss about products I don't like. I usually just return them. In this case, the product was very ill-conceived, as it seemed to clog up after less than 5 seconds of spraying. The instructions say to hold under hot water to unclog, which I've done about 9 times now. Just trying to get the paint off of a 2'x2' square area has taken an hour just to apply the product.

This stuff is incredible. It's the last paint remover type product you'll ever need. Powder coat just peels off in a few minutes. Don't get any on yourself though, it burns. And do it outside or you may pass out. :)

I bought this to strip the coating off some knives and a paintball gun, it worked only mildly. I'll give it another shot with a new knife but I wasn't terribly impressed

This stuff works. Used it to strip fully cured table top epoxy off of a 6 sq ft table. Worked in 2 ft sections, and was done in about an hour and a half (including cleanup). I wish I had thought to take before and after photos because I was really blown away.

By far the best paint/coating remover I have used. Works within minutes, and the old coating practically falls off. It can be easily scraped off with a metal spatula. Be sure to use it outdoors and wear chemical resistant gloves, though, you don't want to breath it in or get it on your skin.

Must of been old stock was not pressurized had to open and use product very dangerous to do but Imanaged to do what I needed . buy this at a store where it is new stock!!!